The effects of hot isostatic pressing (HIP) on crack-network healing, microstructural evolution, and the 900 °C tensile response of additively manufactured MAR-M247 were investigated. X-ray CT showed that HIP markedly reduced the interconnected crack network, with the porosity decreasing from 2.36% to 0.18%. Meanwhile, the original as-printed cellular/dendritic substructure was weakened, boundary-associated particulate phases became more pronounced, and the average characteristic particle size increased from below about 10 nm in the as-printed condition to about 30 nm after HIP. Despite the evident defect healing and microstructural redistribution, no significant improvement in the tensile response at 900 °C was obtained. These results indicate that the high-temperature mechanical benefit of HIP is not automatic, but is jointly governed by crack healing, microstructural redistribution, and second-phase evolution.
Crack formation remains a major barrier to laser powder bed fusion (LPBF) of the high-γ′ Ni-based superalloy MAR-M247 because of severe cyclic thermal loading and interlayer heat accumulation. In this work, an active thermal relaxation (ATR) strategy was introduced into LPBF of MAR-M247 by incorporating an intentional interlayer dwell to regulate the thermal history during multilayer deposition. Through physics-based estimation and experimental screening, a dwell time (Δt) of 10 s was identified as the optimal condition for defect suppression. Under this condition, ATR mitigated heat accumulation, narrowed the heat-affected zone, and reduced residual stress, thereby decreasing the porosity from ~1.52% to ~0.8% and reducing the crack number to only 2–3 in the evaluated regions. Meanwhile, ATR promoted a stronger texture and more continuous columnar solidification features by shifting the solidification path away from the columnar-to-equiaxed transition (CET). These changes in defect state and microstructure resulted in a significant enhancement of tensile performance, with the ultimate tensile strength increasing from 791 MPa to 1027 MPa at room temperature and from 606 MPa to 708 MPa at 900 °C. This work demonstrates that ATR provides a simple and effective thermal-management route for improving the structural integrity and tensile performance of LPBF-fabricated MAR-M247.