UASB reactors are a common technology for wastewater treatment. However, certain disadvantages must be considered. One of the disadvantages relates to the presence of dissolved gases, hydrogen sulfide and methane, in the effluent, which can potentially be released into the atmosphere. This can cause malodours and contribute to the greenhouse effect. In this perspective, this work investigated alternative techniques to minimize these disadvantages: air stripping inside the settling compartment; and a dissipation chamber immediately after the reactor outlet. Results achieved with the air stripping technique showed low removal efficiencies for methane, around 30%, and in the range of 40 to 60% for hydrogen sulfide. On the other hand, the removal efficiencies obtained with the dissipation chamber technique were much higher, consistently reaching 60% or more for both gases, plus a relatively lower exhaust flow. For the best operational condition tested, median removal efficiencies of 73 and 97% were observed for dissolved methane and dissolved sulfide, respectively.
This study aimed at evaluating the microaeration as an alternative for hydrogen sulfide removal from biogas of UASB reactors treating sewage. The set-up consisted of two pilot-scale UASB reactors, including a conventional anaerobic and a modified UASB reactor, operated under microaerated conditions. Air was supplied in the digestion zone, at 1 and 3 m from the bottom of the reactor, and three different air flows were investigated: 10, 20, and 30 mL.min-1, corresponding to 0.003, 0.005 and 0.005 LO2/Linfluent, respectively. The main results showed that the microaeration provided a substantial decrease in hydrogen sulfide concentrations when compared to the concentrations observed in the biogas of the anaerobic UASB reactor. Hydrogen sulfide concentrations remained below 70 ppmv throughout the experimental period, corresponding to an average removal efficiency of 98%. Although a decrease in methane concentrations in biogas was observed, the feasibility of energy use would not be affected. The effect of microaeration on the overall performance of the reactor was evaluated, however, no significant differences were observed. The feasibility of limiting aeration conditions in the reactor digestion zone as an efficient alternative for hydrogen sulfide removal from biogas was demonstrated. GRAPHICAL ABSTRACT
Anaerobic digestion under simplified conditions can contribute to food waste decentralised management. However, there is an absence of knowledge on the effect of long-term operation under these conditions. This study aimed to evaluate the operational conditions of an anaerobic reactor treating food waste after long-term operation without temperature control and low-intensity mixing. For this, a demonstration-scale reactor (18.8 m3) was operated for 160 days, while stability parameters were used to control the applied organic loading rate (OLR). Stability parameters indicated that the reactor was operated at stable conditions with an OLR of 0.3 kg VS m−3 d−1, while it was overloaded at an OLR of 0.4 kg VS m−3 d−1. This was observed through high value of intermediate and partial alkalinity ratio (IA/PA ratio), 2.5, and low values of bicarbonate alkalinity and pH, 1800 mg CaCO3 L−1 and 6.8, respectively. Moreover, there was a change in the concentration of intermediated metabolites, with a higher content of propionate and acetate, 1080 and 3775 mg L−1, respectively. Consequently, the methane production rate was decreased from 0.12 to 0.08 m3 CH4 m−3 d−1 and methane yield from 0.43 to 0.15 m3 CH4 kg VS−1. The reactor instability at a relatively low OLR was most probably due to hydrodynamic factors caused by the accumulation of recalcitrant material. Therefore, this material reduced the reactor performance and requires attention for a sustainable long-term operation. GRAPHICAL ABSTRACT