2 March 2026 in NIPES - Journal of Science and Technology Research
The study presents the simulation-based method for evaluating transformer core materials by considering the spatial nature of magnetic flux lines. The aim is to broaden the design space of materials compared with those conventionally characterised solely by relative permeability and core loss by introducing a pair of field-distribution indices; the compactness index (CI) and symmetry index (SI). Five fundamental materials, Metglas, Silicon Steel, Ferrite, Soft Iron and Solid Iron, were investigated through MATLAB simulation with the basis of a simplified excitation model. Vector field analysis, flux density surface maps, radial flux profile, and angular flux responses were described for each material magnetic features. The simulation results revealed that the best efficiency obtained was Metglas with a compactness index of 99.17, then silicon steel, soft iron, ferrite and solid iron with 44.10, 41.30, 30.08, and 21.74 respectively. The peak value of the flux density for Metglas was about 0.30 T measured just outside the inner radius at r = 0.03 m under a 1 A excitation, and about 0.18 T at r = 0.05 m used for the angular profile. The symmetry index was unity for all materials, ensuring the magnetic field distribution was perfectly balanced in the symmetric excitation geometry. These results demonstrate that while magnetic symmetry is preserved across materials in this geometry, the CI yields a relevant quantitative difference in field performance. The study therefore offers a refined basis for evaluating transformer core materials through a geometry oriented framework that can support compact and thermally stable transformer designs. The results are consistent with analytical expectations and recent FEA studies, highlighting the relevance of CI and SI for modern power systems where magnetic performance must be maximised in compact designs.
10 January 2026 in Journal of Advanced Science and Optimization Research
A new Model Reference Adaptive Control (MRAC) based on minimizing Integral Time Absolute Error (ITAE) model criterion has been designed. However, an obvious challenge to the performance of the ITAE-MRAC method is poor rise time and settling time in positioning control of dish antenna. Thus, Fuzzy Logic Controller (FLC) and Fuzzy-Proportional Derivative plus Integral (Fuzzy-PD+I) controller were designed. The primary purpose of this work is to use intelligent based multi-loop control strategy to achieve efficient positioning control for satellite antenna. Two control strategies were proposed by separately integrating ITAE-MRAC model with FLC and Fuzzy-PD+I controllers. This resulted in multi-loop control systems in which the ITAE-MRAC model forms the outer loop whose output based on the adjustment mechanism was used to adjust the control dynamic of the inner (or secondary) loop controller (FLC or Fuzzy-PD+I). The use of multi-loop makes the inner loop more stable and efficient in providing improved tracking response to setpoint signal. The control models based on PID, ITAE-MRAC, FLC, Fuzzy-PD+I, ITAE-MRAC-FLC, and ITAE-MRAC-Fuzzy-PD+I were separately applied to the dish antenna positioning system. The results obtained from the controllers indicated that the rise times and settling times were improved including good overshoots respectively with zero steady-state error in all cases. The percentage improvement over FLC and Fuzzy-PD+I revealed 30% and 4.95% reduction in rise times and 22% and 1.62% reduction in settling times using ITAE-MRAC-FLC and ITAE-MRAC-Fuzzy-PD+I, respectively. Generally, the results indicated that the use of the ITAE based MRAC model enhanced the performances of the FLC and Fuzz-PD+I, and the overall transient and steady-state response dynamic characteristics of the dish antenna positioning system.