The time-resolved detection of mid- to far-infrared electric fields absorbed and emitted by molecules is among the most sensitive spectroscopic approaches and has the potential to transform sensing in fields such as security screening, quality control, and medical diagnostics. However, the sensitivity of the standard detection approach, which relies on encoding the far-infrared electric field into amplitude modulation of a visible or near-infrared probe laser pulse, is limited by the shot noise of the latter. This constraint cannot be overcome without using a quantum resource. Here, we show that this constraint can be overcome using a two-mode squeezed state. Quantum-correlated ultrashort pulses, generated by parametric down-conversion, enhance the sensitivity of far-infrared detection beyond the classical limit, achieving a twofold reduction in measured noise. This advancement paves the way for further development of ultrafast quantum metrology, moving toward quantum-enhanced time-resolved electric field spectroscopy with sensitivities beyond the standard quantum limit.
Filamentation has extensively been explored and is well understood at repetition rates <1 kHz due to the typical availability of multi-mJ laser systems at a moderate average power. The advent of high-power Yb-lasers opened new possibilities for filamentation research. However, so far, high average power Yb systems have mostly been explored to increase the driving pulse energy to several hundreds of mJ and not at significantly higher repetition rates. In this paper, we study, for the first time, long filaments at unprecedented high repetition rates of 10, 40, and 100 kHz using a 500-W Yb-doped thin-disk amplifier driver operating with sub-700 fs pulses. We compare the filament length, density hole, and fluorescence at a constant peak power but different repetition rates and find a strong dependence on filament length and density depletion with repetition rate. Our analysis reveals the emergence of a significant stationary density depletion at repetition rates of 40 and 100 kHz. The corresponding reduction in the breakdown threshold by increasing the laser repetition rate observed in our study signifies a promising avenue for enhancing the efficiency and reliability of electric discharge triggering in various scenarios. Using capacitive plasma probe measurements, we address the limitations of fluorescence imaging-based measurements and demonstrate a systematic underestimation of filament length. This work contributes to a deeper understanding of the interplay between laser repetition rates, filamentation, and heat-driven density depletion effects from high-repetition-rate high-power laser systems and will contribute to guiding future research, making use of filaments at high repetition rates.
Ytterbium laser sources are state-of-the-art systems that are increasingly replacing Ti:Sapphire lasers in most applications requiring high repetition rate pulse trains. However, extending these laser sources to THz Time-Domain Spectroscopy (THz-TDS) poses several challenges not encountered in conventional, lower-power systems. These challenges include pump rejection, thermal lensing in nonlinear media, and pulse durations exceeding 100 fs, which consequently limit the detection bandwidth in TDS applications. In this article, we describe our design of a THz-TDS beamline that seeks to address these issues. We report on the effectiveness of temperature controlling the Gallium Phosphide (GaP) used to generate the THz radiation and its impact on increasing the generation efficiency and aiding pump rejection while avoiding thermal distortions of the residual pump laser beam. We detail our approach to pump rejection, which can be implemented with off-the-shelf products and minimal customization. Finally, we describe our solution based on a commercial optical parametric amplifier to obtain a temporally compressed probe pulse of 55 fs duration. Our study will prove useful to the increasing number of laboratories seeking to move from the high-energy, low-power THz time-domain spectroscopy systems based on Ti:Sapphire lasers, to medium-energy, high-power systems driven by Yb-doped lasers.