Kazuya Masu

Kazuya Masu

Auto-generated profile, based on publicly available information

Kazuya Masu

Tokyo Institute of Technology

Research Focus & Metrics

Academic Career Length

47Years (1980-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 February 2014 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
DYDaisuke Yamane
Daisuke Yamane
TKT. Konishi
T. Konishi
TMT. Matsushima
T. Matsushima
KMK. Machida
K. Machida
HTH. Toshiyoshi
H. Toshiyoshi
KMK. Masu
K. Masu
This paper presents a design of microelectromechanical systems (MEMS) accelerometers for sensing sub-1g (g = 9.8 m/s2) acceleration. The accelerometer has a high-density proof mass to suppress the Brownian noise that dominates the output noise of the sensor. The low-temperature (<400 °C) process enables to integrate the accelerometer on the sensing complementary metal-oxide semiconductor circuit by electroplating of gold; a proof mass of 1020 μm × 1020 μm in area with the thickness of 12 μm has been found to suppress the measured noise floor to 0.78 μg/Hz at 300 K, which is nearly one order of magnitude smaller than those of the conventional MEMS accelerometers made of silicon.

17 September 1990 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
KTKazuo Tsubouchi
Kazuo Tsubouchi
KMKazuya Masu
Kazuya Masu
NSNobuyuki Shigeeda
Nobuyuki Shigeeda
TMTatsuya Matano
Tatsuya Matano
YHYohei Hiura
Yohei Hiura
NMNobuo Mikoshiba
Nobuo Mikoshiba
We have developed a new controllable method of selective and nonselective deposition of high quality aluminum by low-pressure chemical vapor deposition using dimethylaluminum hydride with hydrogen. At first, silicon dioxide via holes on silicon substrate were selectively filled with aluminum by thermal decomposition. Then, adding the plasma excitation for 1 min, the aluminum film began to deposit nonselectively on the silicon dioxide as well as the selectively deposited aluminum. Silicon dioxide via holes were completely planarized by the selective and nonselective deposition. The single-crystal structure of aluminum deposited selectively on silicon was observed with a new scanning microreflection high-energy electron diffraction microscope.

31 March 2008 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
HIHiroyuki Ito
Hiroyuki Ito
MKMakoto Kimura
Makoto Kimura
KMKazuya Miyashita
Kazuya Miyashita
TITakahiro Ishii
Takahiro Ishii
KOKenichi Okada
Kenichi Okada
KMKazuya Masu
Kazuya Masu
This paper investigates a bidirectional- and multi-drop-transmission-line interconnect for on-chip high-speed networks that have big impact in chip performances. Point-to-point on-chip transmission line interconnects have been developed and demonstrated widely. The present paper applies transmission line interconnect technologies to multipoint-to-multipoint on-chip communications. We propose the novel transceiver that consists of a single differential-amplifier and serves as both a transmitter (Tx) and a receiver (Rx) for transmitting signals to multipoint. The 5-mm-long prototype interconnect with six transceivers performs 8 Gbps signaling with power dissipation of 1.2 mW per transceiver in a 90 nm Si CMOS process. Our interconnect achieves multipoint communications with small delay and high power efficiencies.

1 July 1992 in Journal of Vacuum Science & Technology A
Verified
Journal Article
Closed access
KTKazuo Tsubouchi
Kazuo Tsubouchi
KMKazuya Masu
Kazuya Masu

25 May 2000 in Electronics Letters
Verified
Journal Article
Closed access
JCJ.S. Cha
J.S. Cha
SKS. Kameda
S. Kameda
MYM. Yokoyama
M. Yokoyama
HNH. Nakase
H. Nakase
KMK. Masu
K. Masu
KTK. Tsubouchi
K. Tsubouchi

3 August 2015 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
ASAtsushi Shirane
Atsushi Shirane
YFYiming Fang
Yiming Fang
HTHaowei Tan
Haowei Tan
TITaiki Ibe
Taiki Ibe
HIHiroyuki Ito
Hiroyuki Ito
KMKazuya Masu
Kazuya Masu
This study introduces a 5.8 GHz RF-powered transceiver that includes a transmitter using an IF-based quadrature backscattering (IFQB) technique. The IFQB transmitter can produce a quadrature modulated signal without active RF circuits, such as PLL, local generation, and local distribution circuits. Thus, the IFQB technique can significantly reduce the power consumption while achieving denser constellations by the quadrature modulation. The RF-powered transceiver consists of the IFQB transmitter, an OOK receiver, and a power management unit (PMU) for RF powering. The transmitter and receiver operate under a 0.6 V power supply provided by the PMU to further reduce the power consumption. We fabricated a prototype RF-powered transceiver using a 65 nm Si CMOS process to confirm the validity of the proposed technique. During the measurements, the transmitter achieved 2.5 Mb/s with a 32-QAM modulation while consuming 113 μW. In addition, a wireless temperature sensing demonstration was conducted using the prototype sensor node with the presented RF-powered transceiver.