Choi Look Law

Choi Look Law

Auto-generated profile, based on publicly available information

Choi Look Law

School of Electrical and Electronic Engineering, Nanyang Technological University, Singapore

Research Focus & Metrics

Academic Career Length

42Years (1985-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 June 2004 in IEEE Transactions on Power Delivery
Verified
Journal Article
Closed access
HMH. Meng
H. Meng
SCS. Chen
S. Chen
YGYong Liang Guan
Yong Liang Guan
CLC.L. Law
C.L. Law
PSP.L. So
P.L. So
Tek Tjing LieTek Tjing Lie
Tek Tjing Lie
This paper presents a novel approach to model the transfer function of electrical power lines for broadband power line communication. In this approach, the power line is approximated as a transmission line and the two intrinsic parameters, the characteristic impedance and the propagation constants, are derived based on the lumped-element circuit model. Using these intrinsic parameters, the transfer characteristics for a N-branch power distribution network are derived based on the scattering matrix method. Detail derivation of this line model is given in this paper. The model has been verified with practical measurements conducted on actual power networks. It is demonstrated that the model accurately determine the line characteristics under different network configuration and when different household appliances are connected.

8 August 2005 in IEEE Antennas and Wireless Propagation Letters
Verified
Journal Article
Closed access
ZLZ.N. Low
Z.N. Low
JCJ.H. Cheong
J.H. Cheong
CLC.L. Law
C.L. Law
This letter presents a low-cost knight's helm shape double-sided printed circuit board (PCB) antenna of size 3 cm/spl times/3 cm for ultra-wideband (UWB) application. The antenna has a return loss of more than 10 dB, constant group delay and gain flatness over the frequency range set by the Federal Communications Commission (FCC) for UWB application. Satisfactory performance was obtained using FR4 substrate, allowing low cost of production. This letter also addresses the experimental measurements of group delay and impulse response, which are commonly overlooked.

18 May 2010 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
YZYuan Zhou
Yuan Zhou
CLChoi Look Law
Choi Look Law
YGYong Liang Guan
Yong Liang Guan
FCFrancois Chin
Francois Chin
An asynchronous position measurement system is proposed for indoor localization in this paper. The demonstrated system consists of a UWB transmitter and several energy detection receivers whose positions are known. The position measurement process starts with the locator emitting a UWB pulse. Upon arrival, the pulse is amplified and retransmitted by the target to be located. Signals from both the locator and the target are captured by the receivers. No synchronization mechanism is implemented. Instead, the proposed system measures the differential TOA between the direct coupling signal of the locator and the target signal. Together with the knowledge of the locator transmitter and receiver positions, the absolute range that the pulse travels can be calculated. The sum of transmitter-target range and target-receiver range defines an ellipse and the target resides on the intersections of several such ellipses. It is shown via the Cramer-Rao lower bound that the absolute-range-based elliptical localization is potentially more accurate than the relative-range-based hyperbolic localization. Our proposed system is able to achieve positioning error bound comparable to synchronous absolute-range-based localization systems while eliminating the cost of synchronization.

1 December 2003 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
SPS.K. Padhi
S.K. Padhi
Nemai Chandra KarmakarNemai Chandra Karmakar
Nemai Chandra Karmakar
CLC.L. Law
C.L. Law
SAS. Aditya
S. Aditya
The design and development of a dual linearly polarized aperture coupled circular microstrip patch antenna at C-band are presented. The antenna uses a novel configuration of symmetric and asymmetric coupling slots. Variations in isolation between orthogonal feedlines and antenna axial ratio with the position of coupling slots are studied and broadband isolation and axial ratio are achieved. The prototype antenna yields 7.6 dBi peak gain, 70/spl deg/ 3-dB beam width, 25 dB cross-polarization levels and an isolation better than 28 dB between the two ports. With an external quadrature hybrid coupler connected to the two orthogonal feedlines, the antenna yields 3-dB axial ratio bandwidth of more than 30% at 5.8 GHz.

26 March 2007 in IEEE Antennas and Wireless Propagation Letters
Verified
Journal Article
Closed access
SHSanming Hu
Sanming Hu
HCHonghui Chen
Honghui Chen
CLChoi Look Law
Choi Look Law
ZSZhongxiang Shen
Zhongxiang Shen
LZLei Zhu
Lei Zhu
WDWenbin Dou
Wenbin Dou
Backscattering of ultrawideband (UWB) antennas is theoretically and experimentally studied in this letter. The finite-difference time-domain (FDTD) method using Berenger's perfectly matched layer absorbing boundary condition (PML-ABC) is employed for simulation and the measurement is carried out in indoor environment. Monostatic radar cross section (RCS) of square-slot antenna and printed circular-disc monopole antenna (PCDMA) terminated with three different kinds of loads are numerically calculated and experimentally verified. They are in good agreement in the frequency range from 3 to 11 GHz. Afterwards, scattering characteristics of the structural and antenna modes of two kinds of UWB antenna structures are extensively characterized in both the frequency domain and time domain

1 August 2003 in Journal of Geodesy
Verified
Journal Article
Closed access
PDF file
GHG.R. Hu
G.R. Hu
HKH.S. Khoo
H.S. Khoo
PGP.C. Goh
P.C. Goh
CLC.L. Law
C.L. Law