Gang Wu

Gang Wu

Auto-generated profile, based on publicly available information

Gang Wu

Nanjing University of Aeronautics and Astronautics

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 November 2017 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
GWGang Wu
Gang Wu
XRXinbo Ruan
Xinbo Ruan
ZYZhihong Ye
Zhihong Ye
Due to the relatively low output voltage of photovoltaic (PV) source, a high step-up converter with high efficiency is needed when the PV source is connected to the power grid. A novel high step-up converter based on two switched capacitors and a coupled inductor is proposed in this paper. The operating principle is analyzed and the voltage gain is derived. A 100-W prototype is fabricated in the laboratory to verify the theoretical analysis, and the highest efficiency is 96.4%.

15 February 2017 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
FYFei Yang
Fei Yang
XRXinbo Ruan
Xinbo Ruan
GWGang Wu
Gang Wu
ZYZhihong Ye
Zhihong Ye
A two-phase interleaved boost dc-dc converter with an inversely coupled inductor in a discontinuous-current mode (DCM) is analyzed by the equivalent inductance method. Coupling effects on the circuit statuses are described, and a forced conduction of the power diode or reverse-paralleled diode of MOSFET is caused by coupling. As a result, three major circuit statuses are figured out according to the physical relationship between the input-output voltage ratio and the coupling coefficient, and their condition boundaries are used to classify the DCM operation modes. Then, considering the load (duty cycle) variation, ten DCM operation modes are comprehensively analyzed. The analysis can be used to make an easy prediction of operation modes, and extended to the analysis of an interleaved buck converter or buck/boost bidirectional converter with a coupled inductor in DCM. At last, a 300-W prototype is built and tested in the lab to verify the analysis.

1 December 2017 in Journal of Modern Power Systems and Clean Energy
Verified
Journal Article
Open access
PDF file
GWGang Wu
Gang Wu
XRXinbo Ruan
Xinbo Ruan
ZYZhihong Ye
Zhihong Ye
For grid-connected power system based on photovoltaic (PV) source and fuel cells, high step-up and high-efficiency DC–DC converters are needed, due to the bus voltage of the grid-connected inverter is much higher than the output voltage of PV and fuel cells. In this paper, a novel high step-up converter is proposed. An auxiliary capacitor is introduced into the boost converter, which serves as a voltage source. It is in series with the input voltage source with the same voltage polarities. Thus, the input voltage is increased equivalently and the voltage gain is increased accordingly. To reduce the voltage stresses of the switch and the diode, multiple output capacitors are introduced. The voltage of each output capacitor is degraded leading to the reduced voltage stress. To replenish energy for the multiple output capacitors, a coupled inductor is adopted. Based on this, high step-up converter adopting auxiliary capacitor and coupled inductor is derived. The operating principles and voltage gain of the proposed converters are analyzed in this paper. In the end, experiment results are given to verify the theoretical analysis.