A single-chip, bidirectional brain-computer interface (BBCI) enables neuromodulation through simultaneous neural recording and stimulation. This article presents a prototype BBCI application-specified integrated circuit (ASIC) consisting of a 64-channel time-multiplexed recording front-end, an area-optimized four-channel high-voltage compliant stimulator, and electronics to support the concurrent multi-channel stimulus artifact cancellation. Stimulator power generation is integrated on a chip, providing ±11-V compliance from low-voltage supplies with a resonant charge pump. High-frequency (~3 GHz) self-resonant clocking is used to reduce the pumping capacitor area while suppressing the associated switching losses. A 32-tap least mean square (LMS)-based digital adaptive filter achieves 60-dB artifact suppression, enabling simultaneous neural stimulation and recording. The entire chip occupies 4 mm² in a 65-nm low power (LP) process and is powered by 2.5-/1.2-V supplies, dissipating 205 μW in recording and 142 μW in the stimulation and cancellation back-ends. The stimulation output drivers achieve 31% dc-dc efficiency at a maximum output power of 24 mW.
31 December 2019 in IEEE Transactions on Biomedical Circuits and Systems
This article demonstrates a scalable, time-division multiplexed biopotential recording front-end capable of real-time differential- and common-mode artifact suppression. A delta-encoded recording architecture exploits the power spectral density (PSD) characteristics of Electrocorticography (ECoG) recordings, combining an 8-bit ADC, and an 8-bit DAC to achieve 14 bits of dynamic range. The flexibility of the digital feedback architecture is leveraged to time-division multiplex 64 differential input channels onto a shared mixed-signal front-end, reducing channel area by 2x compared to the state-of-the-art. The feedback DAC used for delta-encoding also serves to cancel differential artifacts with an off-chip adaptive loop. Analysis of this architecture and measured silicon performance of a 65 nm CMOS test-chip implementation, both on the bench and in-vivo, are included with this paper.