25 November 2019 in IEEE Access
Silicon carbide (SiC) devices have shown substantial promise in realizing ultrahigh-voltage and high power, and have been usually considered as a potential candidate for high radiation levels applications. However, in this work it is found that the SiC P-intrinsic-N (PiN) diodes are sensitive to the electron irradiation, which exerts significant influence on the device characteristics. The physical mechanisms behind these behaviors are studied by probing the production of point defects and the evolution of carrier lifetime in the SiC epilayers after irradiation. It is found that the forward current is significantly reduced by irradiation and the specific on-resistance monotonously increases with the increasing electron fluences, which is resulted from the deteriorated conductivity modulation effects in the epilayer due to the enhanced carrier recombination from the radiation induced deep-level defects, such as the carbon vacancy (VC), silicon vacancy (VSi) and VC+VSi complexes. Inversely, no significant change is observed in the reverse leakage current of 4H-SiC PiN diodes, and the breakdown voltage even slightly increases after electron irradiation, which are ascribed to the suppressed carrier generation arising from the point defects in 4H-SiC with a wide bandgap and the carrier-removal effects caused by the acceptor like point defects generated during irradiation, respectively.
2 March 2021 in Physical Review Applied
The interface in the termination area is a crucial component in limiting high-temperature reverse-bias (HTRB) reliability for -based high-voltage devices. However, the atomic structure and carrier-trapping behavior of the interface defects therein and the underlying physical mechanisms of breakdown-voltage () variation are still largely unclear. Here, the interface defects of 4H- gate turn-off (GTO) thyristors before and after HTRB stress are investigated by transient capacitance measurements and density-functional-theory (DFT) calculations. It is found that the bias stress at 4.4 kV enlarges the interface state density at eV to eV by electron capturing. As a result, the negative interface charge is generated. As high-resolution transmission electron microscopy reveals the presence of excess carbon near the surface, DFT calculations are focused on carbon-related interface defects to clarify the atomic and electronic structures of the interface trap and assign them to negatively charged excess split-interstitial carbon at the interface. Furthermore, technical computer-aided-design simulation further proves that the negatively charged interface defect is the main cause for the observed degradation after the HTRB test, which leads to a strong electric field crowding effect. These results not only provide deep physical insights underlying degradation in HTRB-stressed high-voltage devices, but are also of significant importance in the optimizations of device structure and oxidation technology for interfaces in high-voltage devices.
3 February 2021 in IEEE Transactions on Nuclear Science
Wide-gap semiconductor SiC is generally considered as a superior candidate for high-radiation applications, due to its higher displacement energy for both Si and C lattice atoms. In this work, we find that the current gain (β) of 4H-SiC bipolar junction transistors (BJTs) can severely deteriorate after neutron irradiation. Deep-level transient spectroscopy (DLTS) reveals that two major carrier-killer centers, Z1/2 and EH6/7, were produced in neutron-irradiated devices. Surprisingly, we find that the shallow Z1/2 center can play a dominant role over the deep EH6/7 defects in carrier recombination under high-injection conditions, which contributes to the unusual smaller hole capture cross section than that of the electron one, as indicated by the first-principles calculations. Finally, technology computer aided design (TCAD) simulation confirms that the enhanced carrier recombination from the Z1/2 centers is responsible for the degraded performance of SiC BJTs after irradiation. Our findings not only provide a deep insight into the underlying physics for displacement damage in SiC BJTs, but also are of interest for technological applications field related to high-energy particle irradiation or implantation.
19 December 2023 in IEEE Transactions on Electron Devices
The robustness of silicon carbide (SiC) metal–oxide–semiconductor field-effect transistor (MOSFET) under harsh environments is a crucial factor to ensure power conversion system safely and continuously operating. In this work, the degradation behaviors and mechanisms of switching characteristics after gamma-ray radiation were comprehensively investigated, presenting the link of atomic-scale defects to device properties behaviors. The changes in turn-on and turn-off characteristics after irradiation are recorded and first analyzed in terms of the capacitance and static parameters characterizations. The decrease of the threshold voltage ( ${V}_{\text {th}}$ ) plays a dominant role in the accelerated turn-on and delayed turn-off processes over the capacitance ${C}_{\text {GS}}$ . The trapped interface and oxide charge in SiC MOSFETs as a function of radiation dose are separated from the subthreshold characteristics, which are suggested to result in the ${V}_{\text {th}}$ shifts and ${C}_{\text {GS}}$ changes. Deep-level transient spectroscopy measurements were performed to investigate the involved interface defects during irradiation. It is suggested that the oxygen vacancy in the oxide and SiC/SiO2 interface defects locating from ${E}_{\text {C}} -0.2$ to ${E}_{\text {C}} -0.6$ eV act as hole and electron trapping centers during irradiation, respectively, and thus lead to the degradations of switching performances of SiC MOSFETs.
1 September 2019 in IEEE Transactions on Electron Devices
16 April 2024 in Results in Physics