22 September 2022 in Journal of Physics D: Applied Physics
Crystalline silicon solar cells are always moving towards ‘high efficiency and low cost’, which requires continuously improving the quality of crystalline silicon materials. Nevertheless, crystalline silicon materials typically contain various kinds of impurities and defects, which act as carrier recombination centers. Therefore these impurities and defects must be well controlled during the solar cell fabrication processes to improve the cell efficiency. Hydrogenation of crystalline silicon is one important method to deactivate these impurities and defects, which is so-called ‘hydrogenation engineering’ in this paper. Hydrogen is widely reported to be able to passivate diverse defects like crystallographic defects, metallic impurities, boron-oxygen related defects and etc, but the effectiveness of hydrogen passivation depends strongly on the processing conditions. Moreover, in this decade, advanced hydrogenation technique has been developed and widely applied in the photovoltaic industry to significantly improve the performance of silicon solar cells. As the research on hydrogenation study has made a significant progress, it is the right time to write a review paper on introducing the state-of-the-art hydrogenation study and its applications in photovoltaic industry. The paper first introduces the fundamental properties of hydrogen in crystalline silicon and then discusses the applications of hydrogen on deactivating/inducing typical defects (e.g. dislocations, grain boundaries, various metallic impurities, boron–oxygen related defects and light and elevated temperature induced degradation defect) in p- and n-type crystalline silicon, respectively. At last, the benefits of hydrogenation engineering on the next-generation silicon solar cells (e.g. tunnel oxide passivated contact (TOPCon) and silicon heterojunction (SHJ) solar cells) are discussed. Overall, it was found that hydrogen can deactivate most of typical defects (sometimes induce defect) in n- and p-type crystalline silicon, leading to a significant efficiency enhancement in passivated emitter rear contact, TOPCon and SHJ solar cells. In conclusion, the paper aims to assist young researchers to better understand hydrogenation research.
27 April 2024 in Journal of Non-Crystalline Solids
2 March 2021 in Physical Review Applied
The interface in the termination area is a crucial component in limiting high-temperature reverse-bias (HTRB) reliability for -based high-voltage devices. However, the atomic structure and carrier-trapping behavior of the interface defects therein and the underlying physical mechanisms of breakdown-voltage () variation are still largely unclear. Here, the interface defects of 4H- gate turn-off (GTO) thyristors before and after HTRB stress are investigated by transient capacitance measurements and density-functional-theory (DFT) calculations. It is found that the bias stress at 4.4 kV enlarges the interface state density at eV to eV by electron capturing. As a result, the negative interface charge is generated. As high-resolution transmission electron microscopy reveals the presence of excess carbon near the surface, DFT calculations are focused on carbon-related interface defects to clarify the atomic and electronic structures of the interface trap and assign them to negatively charged excess split-interstitial carbon at the interface. Furthermore, technical computer-aided-design simulation further proves that the negatively charged interface defect is the main cause for the observed degradation after the HTRB test, which leads to a strong electric field crowding effect. These results not only provide deep physical insights underlying degradation in HTRB-stressed high-voltage devices, but are also of significant importance in the optimizations of device structure and oxidation technology for interfaces in high-voltage devices.
10 April 2021 in Solar RRL
15 July 2025 in Journal of Non-Crystalline Solids
19 October 2023 in Silicon