10 June 2018 in Advanced Science
Performance degradation is one of the key obstacles limiting the commercial application of organic photovoltaic (OPV) devices. The assessment of OPV stability and lifetime are usually based on simulated degradation experiments conducted under indoor conditions, whereas photovoltaic devices experience different environmental conditions under outdoor operation. Besides the intrinsic degradation of OPV devices due to the evolution of optoelectronic and morphological structure during long‐term operation, outdoor environmental changes can impose extra stresses and accelerate the degradation of OPV modules. Although outdoor studies on long‐term OPV stability are restricted by the long data collection times, they provide direct information on OPV stability under mixed degradation stresses and are therefore invaluable from the point of view of both research and practical application. Here, an overview of the current status of outdoor lifetime studies of OPVs is provided. After a summary of device lifetime extrapolated from indoor studies, outdoor lifetime testing platforms are introduced and the operational lifetime of various OPV devices are reviewed. The influence of climate and weather parameters on device performance and burn‐in phenomena observed during the degradation of OPVs is then discussed. Finally, an outlook and directions for future research in this field are suggested.
27 October 2016 in Advanced Materials
1 April 2019 in Chemistry of Materials
9 February 2016 in Scientific Reports
We present measurements of the outdoor stability of PCDTBT:PC71BM based bulk heterojunction organic solar cells for over the course of a year. We find that the devices undergo a burn-in process lasting 450 hours followed by a TS80 lifetime of up to 6200 hours. We conclude that in the most stable devices, the observed TS80 lifetime is limited by thermally-induced stress between the device layers, as well as materials degradation as a result of edge-ingress of water or moisture through the encapsulation.
2 May 2017 in Scientific Reports
We report comparative indoor and outdoor stability testing of organic solar cells based on a blend between a donor-acceptor polyfluorene copolymer and a fullerene derivative. The outdoor testing was conducted for a period over 12,000 hours in Sheffield, England, with a Ts80 lifetime determined in excess of 10,000 hours (420 days). Indoor lifetime testing was performed on solar cells using a solar simulator under a constant irradiance of 1000 W/m2 for more than 650 hours. We show that under the conditions explored here, device degradation under the two sets of conditions is approximately dependent on the absorbed optical energy dose.
18 May 2015 in RSC Advances
The effect of fluorine substitution on the ubiquitously-studied, moderate band gap polymer, poly(2,7-fluorene-alt-dithienylbenzothiadiazole) (PFO-DBT) has been investigated by substituting the hydrogen atoms at the 5,6-positions of benzothiadiazole to yield the polymer, PFO-DffBT. An analogous polymer, PFDo-DffBT, with longer chains on the 9H-positions of the fluorene moiety, was synthesised to rectify the low Mw of PFO-DffBT. In thin films, both fluorinated polymers display absorption bands with well-defined shoulders, giving optical band gaps of 1.91 and 1.89 eV, respectively. The optical band gap of PFDo-DBT is identical to that of PFDo-DffBT, despite the former having a significantly larger Mw. However, PFDo-DffBT displayed a blue-shifted λmax relative to its non-fluorinated counterpart. The HOMO levels of PFO-DffBT and PFDo-DffBT are lower than their non-fluorinated analogues, owing to the incorporation of electron withdrawing substituents on the benzothiadiazole moiety. The photovoltaic properties of all polymers were investigated by fabricating bulk heterojunction (BHJ) polymer solar cells using PC70BM as the electron acceptor. PFO-DffBT displayed the highest efficiency with a PCE of 4.4% despite having the lowest Mw of all polymers studied.