1 November 2024 in APL Photonics
The development of compact fiber-based light sources emitting over a wide wavelength range in the mid-infrared and their application to the detection of greenhouse gases and volatile organic compounds still remain of critical interest. In the present work, we make use of several dedicated infrared fibers for implementing a mid-infrared optical device pumped by a thulium doped-fiber laser around 1.965 μm that simultaneously enables a first nonlinear stage of frequency conversion and supercontinuum generation and a second linear stage of gas absorption spectroscopy. As a proof-of-principle, we carry out mid-infrared supercontinuum absorption spectroscopy of methane around 7.7 μm by means of a hollow-core fiber-based gas cell combined to a commercial Fourier-transform infrared spectrometer. Our all-fiber configuration operating in the femtosecond regime at megahertz repetition rate allows the detection of methane concentrations as low as 20 ppm.
23 April 2025 in Photonics Research
Simultaneously increasing the spectral bandwidth and average output power of mid-infrared supercontinuum sources remains a major challenge for their practical application. We particularly address this issue for the long mid-infrared spectral region through experimental developments of short tapered rods made from selenide glass by means of supercontinuum generation in the femtosecond regime. Our simple post-processing of glass rods unlocks potentially higher-power and coherent fiber-based supercontinuum sources beyond the 10-μm waveband. By using a 5-cm-long tapered Ge-Se-Te rod pumped at 6 μm, a supercontinuum spanning from 2 to 15 μm (3–14 μm) with an average output power of 93 mW (170 mW) is obtained for 500-kHz (1-MHz) repetition rate. Additional experiments on other glass families (silica and tellurite) covering distinct spectral regions are also reported to develop and support our analyses. We demonstrate that ultra-broadband spectral broadenings over entire glass transmission windows can be achieved in few-cm-long segments of tapered rods by a fine adjustment of input modal excitation. Numerical simulations are used to confirm the main contribution of the fundamental mode in the ultrafast nonlinear dynamics, as well as the possible preservation of coherence features. Our study opens a new route, to our knowledge, towards the power scaling of high-repetition-rate fiber supercontinuum sources over the full molecular fingerprint region.
30 August 2025 in Communications Materials
The mid-infrared (MIR) photonics market is rapidly expanding, driven by advancements in fiber-based MIR devices, particularly fiber lasers. However, the lack of robust MIR optical fibers remains a critical barrier to further technological progress. In this work, we present the fabrication of gallate glasses containing tantalum oxide, as it stands, the most robust mid-infrared glasses capable of being easily shaped into large bulk components, fibers or tapers. By introducing up to 20 mol% of tantalum oxide in a gallate glass, we achieve a two-order-of-magnitude improvement in water corrosion resistance, while the nonlinear refractive index increases tenfold compared to silica. Optimal thermal stability is attained at 10 mol% of tantalum oxide, enabling the fabrication of tens-of-meter-long optical fibers. Crucially, the addition of tantalum oxide enhances the gallate glass properties without compromising thermomechanical performance. The potential of these tantalo-gallate glasses is further demonstrated through supercontinuum generation in a laser-inscribed waveguide and a tapered fiber, spanning from the visible to 4.5 μm. This work establishes our developed tantalo-gallate glasses as a compelling alternative for photonic applications seeking robust mid-infrared materials, with the potential to overcome the critical barriers currently limiting the advancement of fiber-based MIR technologies.
16 October 2023 in Optics Letters
We report on the experimental development of short-tapered chalcogenide-glass rods for mid-infrared supercontinuum generation. Multi-octave spectral broadening of femtosecond laser pulses is demonstrated from 1.6 to 15.6 µm in a 5-cm-long tapered Ge20Se70Te10 rod with a waist diameter of 25 µm. Despite the multimode nature of the optical waveguide used, this work clearly shows the potential of such simple post-processed rods for advancing fiber SC sources with infrared glasses, thereby unlocking new possibilities in terms of coupling efficiency, spectral coverage, and output power.
7 September 2022 in Optical Materials: X
24 February 2026 in Journal of the Optical Society of America B
Over the past decades, fiber-based supercontinuum (SC) sources spanning 1–5 µm have been extensively investigated for a wide range of applications. To meet the growing demand for higher output power and stability, the development of glass fibers combining excellent thermomechanical properties with high nonlinearity is essential. In this work, we report the fabrication of robust niobium-containing gallate glasses. Incorporating niobium oxide up to 20 mol.% significantly improves thermomechanical performance, with a 20% hardness increase and a two-order-of-magnitude improvement in water corrosion resistance over niobium-free glass. Simultaneously, the nonlinear refractive index more than doubles, exceeding that of silica by over an order of magnitude. Importantly, the thermal dilatometric properties remain largely unaffected, enabling the fabrication of niobium-rich gallate step-index multimode fibers. These fibers were successfully employed to generate a supercontinuum spanning from 600 nm to 4.5 µm. Numerical simulations further optimized the step-index design under realistic pumping conditions near 2 µm, consistent with mature thulium-doped fiber lasers. Owing to their unique balance of thermomechanical robustness and high nonlinearity, niobium gallate fibers emerge as strong candidates for power-scalable, reliable all-fiber SC sources, with the potential to deliver high average powers across the 0.5–4.5 µm range.