Chrysanthemum flower-like NiCo2O4–nitrogen doped graphene oxide composite material has been explored as a bifunctional cathode electrocatalyst for aqueous zinc–air and non-aqueous lithium–oxygen batteries. This cathode exhibits maximum discharge capacities of 712 and 15 046 mA h g−1 for zinc–air and lithium–oxygen batteries, respectively, with stable cycling over 50 cycles.
11 September 2020 in Journal of Materials Chemistry A
The rechargeable zinc–air battery is a clean technology for energy storage applications but is impeded by the slow kinetics of the oxygen reduction reaction (ORR) and oxygen evolution reaction (OER) during its cycling. Herein, a series of lanthanum cobaltate based perovskites are synthesised with the B-site cation deficiencies in the structure occupied by Ru substitution: LaCo1−xRuxO3−δ (x = 0, 0.1, 0.2, 0.3 and 0.5). These compositions were designed to enhance the OER/ORR activities, which are two vital reactions for rechargeable Zn–air batteries. Powder X-ray diffraction analysis revealed that increasing the Ru substitution >20% (x > 0.2) alters the LaCoO3 crystal structure from rhombohedral to orthorhombic. Photoelectron spectroscopy studies reveal that the surface oxygen vacancies increased in the Ru substituted catalyst, a property important for enhancing the OER/ORR efficiency. The LaCo0.8Ru0.2O3−δ (LCRO82) catalyst exhibits promising electrocatalytic activities in both the OER and the ORR in 0.1 M KOH solution. Furthermore, the LCRO82 catalyst was evaluated as a cathode for rechargeable Zn–air battery applications displaying a high power density of 136 mW cm−2 at a current density of 175 mA cm−2 and a stable charge–discharge voltage gap of 0.78 V after 1440 cycles, with excellent cycling stability over 240 h.
1 July 2020 in International Journal of Hydrogen Energy
Graphene oxide (GO) and multi-walled carbon nanotubes (MWCNT) were incorporated into a SiOC composite ceramic matrix using a simple roll-mixing method followed by thermal cross-linking and pyrolysis. The structure, morphology, porosity, surface characteristics, and thermal properties of polysiloxane are analysed using scanning electron microscopy, BET specific surface area, mercury intrusion porosimetry, water vapour and n-heptane adsorption, and Raman spectroscopy, respectively. The electrical conductivity, conduction mechanism, and percolation behavior of the composite ceramics are investigated by electrical impedance spectroscopy in the temperature range of 25–250 °C. Free-rising composite ceramic foams are generated, incorporating both nanofillers into the SiOC ceramic matrix. Both nanofillers show a positive effect on the thermal stability of the SiOC ceramics. The room temperature DC conductivity value of pure SiOC ceramics shows ∼2.97 × 10−9 S cm−1, which increases by three to four orders of magnitude after the incorporation of 5 wt% conductive nanofillers (∼2.5 × 10−6 S cm−1 for 5 wt% GO and ∼2.08 × 10−5 S cm−1 for 5 wt% MWCNT). The calculated activation energy from the Arrhenius plot for composite ceramics is found to be lower (0.10 eV for 5 wt% GO and 0.07 eV for 5 wt% MWCNT) compared to the same SiOC ceramics without nanofillers (0.22 eV). The conduction mechanism studies of composite ceramics suggest a non-Debye type distribution of relaxation in SiOC. Thus the nanofiller-enhanced SiOC ceramics are highly promising materials for rechargeable batteries, high-temperature fuel cells, gas sensors, display devices etc.