8 January 2025 in Journal of Laser Applications
This study investigates the fabrication of blind holes in Inconel 718 alloy using a quasi-continuous wave (QCW) laser under varying pulse numbers. The geometric features, spatter formation, inner wall morphology, and microstructures of the drilled holes were systematically analyzed. Experimental results demonstrate that increasing the number of laser pulses from 1 to 13 significantly improves the hole depth, ranging from 565.09 to 3952.54 μm, achieving a maximum depth-to-diameter ratio of 9.5. Shallow holes exhibited optimal morphology with clean edges and smooth inner walls, whereas deeper holes displayed a composite structure consisting of inverted cone (upper), cylindrical (middle), and spindle-shaped (lower) sections. The thickness of the recast layer increased along the depth as the pulse numbers rose. Microstructural analysis revealed that the recast layer contained refined grains, with kernel average misorientation analysis indicating high residual stress within this layer. The hardness of the recast layer, measured at 2.13 GPa, was notably lower than that of the base material (4.49 GPa), primarily due to the depletion of the strengthening phase and the formation of the Laves phase. This work provides an in-depth understanding of the characteristics and mechanisms of QCW laser drilling in Inconel 718 alloy, offering valuable insights to optimize the laser processing parameters for industrial applications.
27 May 2026 in SSRN Electronic Journal
This paper presents a dual-gas step-wise femtosecond laser machining for SiCf/SiC ceramic matrix composiste (CMC) strategy based on the systematic investigation of material removal mechanisms under different assist gases. Results indicate that compressed air achieves highly efficient material removal (up to 31.5 mm3/min) by utilizing exothermic oxidation, but induces severe oxidation and recast layers. Conversely, N2 achieves a clean surface dominated by physical ablation due to its excellent momentum transfer and cooling capacity. Consequently, an Air-roughing + N2-finishing step-wise strategy is proposed: compressed air rapidly opens the channel, followed by N2 finishing via strong aerodynamic shear. Under optimized parameters, machining a 10 mm × 3 mm through-slots takes only ~88 s with a near-zero taper. This strategy also eliminates oxide and porous defects. The full-depth areal roughness Sa<0.6 μm (an 80% reduction vs. processing with air). This strategy provides a highly efficient and precise manufacturing route for SiCf/SiC CMC.
11 October 2026 in SSRN Electronic Journal
Improving the efficiency of femtosecond laser machining of carbon fiber-reinforced polymer (CFRP) is limited by heat accumulation and laser-induced plume shielding at high average power. In this study, a kilowatt-class continuous-GHz (cGHz) femtosecond laser was combined with ultrafast polygon scanning (>80 m/s) for high-efficiency and low-thermal damage CFRP processing. The results show that carbon fiber orientation regulates heat transport and thermal damage, while ultrafast scanning promotes spatial separation between the laser-material interaction region and the expanding plume, thereby reducing plume shielding effect. A maximum material removal rate (MRR) of 1240.2 mm3/min for line scanning and a minimum surface roughness of Ra 1.8 μm for surface milling were achieved. The in-plane heat-affected zone (HAZ) width decreased from 44.01 to 9.57 μm as the scanning direction changed from perpendicular to parallel to the carbon fibers, while the depth-direction HAZ remained within approximately 5 μm. An effective ablation threshold of approximately 0.012 J/cm2 was obtained. These results reveal the roles of anisotropic heat transport and plume shielding in high-power cGHz femtosecond laser processing of CFRP, providing a basis for high-efficiency and low-damage machining of composite materials.