31 December 2024 in Avtoshliakhovyk Ukrayiny
KUKremenchuk Mykhailo Ostrohradskyi National University
Kremenchuk Mykhailo Ostrohradskyi National University
Calculations were made on the strength of the hot-rolled channel made of low-alloy steel produced by the metallurgical plant “Metinvest” (Ukraine) and the lightweight cold-bent channel made of high-strength steel produced by the metallurgical plant “Voestalpine AG” (Austria) for the frame spars of a heavy-duty vehicle – the KrAZ-6510TE tractor unit, as the most powerful and a loaded car from the model range of KrAZ cars, with the determination of stresses in the spars and critical zones under the condition of strength and magnitude of the spars’ bending deformation from static loads and. The calculations were carried out taking into account the chemical composition and mechanical properties of the materials, the geometric characteristics of the cross-sections of the channels by computer modeling with visualization of the determined stresses and critical zones in the spars. The study of loads on the frame was carried out according to the methodology of determining the static load on the frame of a stationary car from the sprung masses of hinged units and aggregates, which is then multiplied by the dynamism coefficient, which takes into account the increase in the load on the frame depending on road conditions and the speed of the car. The stress distribution in the frame spars was determined according to the IV theory of strength (ac-cording to Mises). Conclusions were made about the expediency of using lightweight cold-bent channels made of high-strength steel for the manufacture of frame spars of KrAZ heavy-duty trucks, as a result of which the strength and reliability of the frames is ensured with a significant saving of metal. Recommendations are provided for strengthening frame spars in critical areas. Research results can be applied to all models of KrAZ trucks. Keywords: truck, vehicle supporting system, frame strength, frame spars, channel profile, low-alloy steel, spar stress, spar deflection.
1 January 2024 in Transactions of Kremenchuk Mykhailo Ostrohradskyi National University
1 January 2025 in Transactions of Kremenchuk Mykhailo Ostrohradskyi National University
19 November 2025 in СУЧАСНІ ТЕХНОЛОГІЇ В МАШИНОБУДУВАННІ ТА ТРАНСПОРТІ
On modern electric vehicles, the traction battery is installed from below on the bottom of the body, which reduces the height of the vehicle's center of gravity and improves the vehicle's lateral stability during curved movement. The disadvantage of this arrangement is the increased risk of damage and destruction of the protective housing and, accordingly, the battery's electrical elements, which are dozens of ordinary household lithium-ion batteries of the AAA type. But the housings of these electrical elements are manufactured using a special technology that helps increase the strength of the housing and from a material with high heat dissipation. It is shown that the traction battery is the most expensive component of an electric vehicle. Therefore, the development of production methods aimed at increasing its service life is an urgent task. The mechanical characteristics of anisotropic material were taken into account during the manufacture of reinforced containers for electrical element housings. Data were determined that reliably reflect the influence of the stretching coefficient, planar anisotropy and the initial diameter of the work piece on the critical thickness of its plate. An expression was obtained that takes into account all the characteristics of the technological process that affect the thickness of the initial work piece. This allows you to control these characteristics in order to optimize the thickness of the work piece. The dependence obtained as a result of the study allows you to accurately and qualitatively calculate the optimal thickness of the initial work piece at the stage of developing the technological process for manufacturing battery cell housings for electric vehicles. Key words: electric car, lithium-ion battery, battery protection, anisotropic materials.