Polycrystalline diamond (PCD) films are usually grown by chemical vapor deposition (CVD) in hydrogen–methane mixtures. The synthesis conditions determine the structure and quality of the grown material. Here, we report the complex effect of the microwave plasma CVD conditions on the morphology, growth rate and phase composition of the resulting PCD films. Specifically, we focus on the factors of (i) increased methane concentrations () that are varied over a wide range of 4%–100% (i.e., pure methane gas) and (ii) substrate temperatures () varied between 700–1050 °C. Using scanning electron microscopy, X-ray diffraction and Raman spectroscopy, we show that diamond growth is possible even at ultrahigh methane concentrations, including = 100%, which requires relatively low synthesis temperatures of < 800 °C. In general, lower substrate temperatures tend to facilitate the formation of higher-quality PCD films; however, this comes at the cost of lower growth rates. The growth rate of PCD coatings has a non-linear trend: for samples grown at = 800 °C, the growth rate increases from 0.6 µm/h at = 4% to 3.4 µm/h at = 20% and then falls to 0.6 µm/h at = 100%. This research is a step toward control over the nature of the CVD-grown PCD material, which is essential for the precise and flexible production of diamond for various applications.
The patterning and transfer of a two-dimensional graphene film without damaging its original structure is an urgent and difficult task. For this purpose, we propose the use of the blister-based laser-induced forward transfer (BB-LIFT), which has proven itself in the transfer of such delicate materials. The ease of implementation of laser techniques reduces the number of intermediate manipulations with a graphene film, increasing its safety. The work demonstrates the promise of BB-LIFT of single-layer graphene from a metal surface to a SiO2/Si substrate. The effect of the parameters of this method on the structure of transferred graphene islands is investigated. The relevance of reducing the distance between irradiating and receiving substrates for the transfer of free-lying graphene is demonstrated. The reasons for the damage to the integrity of the carbon film observed in the experiments are discussed. The preservation of the original crystal structure of transferred graphene is confirmed by Raman spectroscopy.