This study proposes to estimate the actual crop evapotranspiration, using the SAFER model, as well as calculate the crop coefficient (Kc) as a function of the normalized difference vegetation index (NDVI) and determine the biomass of an irrigated maize crop using images from the Operational Land Imager (OLI) and Thermal Infrared (TIRS) sensors of the Landsat-8 satellite. Pivots 21 to 26 of a commercial farm located in the municipalities of Bom Jesus da Lapa and Serra do Ramalho, west of Bahia State, Brazil, were selected. Sowing dates for each pivot were arranged as North and South or East and West, with cultivation starting firstly in one of the orientations and subsequently in the other. The relationship between NDVI and the Kc values obtained in the FAO-56 report (KcFAO) revealed a high coefficient of determination (R2 = 0.7921), showing that the variance of KcFAO can be explained by NDVI in the maize crop. Considering the center pivots with different planting dates, the crop evapotranspiration (ETc) pixel values ranged from 0.0 to 6.0 mm d-1 during the phenological cycle. The highest values were found at 199 days of the year (DOY), corresponding to around 100 days after sowing (DAS). The lowest BIO values occur at 135 DOY, at around 20 DAS. There is a relationship between ETc and BIO, where the DOY with the highest BIO are equivalent to the days with the highest ETc values. In addition to this relationship, BIO is strongly influenced by soil water availability.
The sustainable production of inputs or products, either agricultural or industrial, has become an international concern in the last years. Thus, one of the biggest challenges today is to combine production with sustainability. An alternative that has been gaining strength is the use of industrial waste in agriculture. Therefore, the objective of this study was to evaluate the development, physiology and quality of seedlings of C. canephora from the thirteen genotypes found in the variety Vitória Incaper 8142, in conventional substrate in comparison to a substrate based on tannery sludge. A 2 x 13 factorial arrangement was used in which the first factor was the two substrates (conventional substrate and substrate with tannery sludge), and the second factor was the 13 Vitória - Incaper 8142 Conilon coffee genotypes, arranged in a randomized block design with four repetitions. No significant interaction was observed between the factors evaluated, genotypes and substrates. Despite the fact that plants grown on substrate based on tannery sludge show lower averages in some characteristics, they were not different in terms of seedling quality index, so the substrate based on tannery sludge has strong potential for use. This substrate also promoted a greater production of defense metabolites in plants. As for the response pattern between the genotypes of the Vitória - Incaper 8142 variety, a high unevenness was observed in the initial development, both for their phenological and physiological characteristics, which is a reflect of the genetic variability existing between the genotypes. Key words: Seedling production; Coffe canephora; physiology; sustenaibility.
17 February 2020 in REVISTA ENGENHARIA NA AGRICULTURA - REVENG
Among the reference evapotranspiration (ETo) equations, the FAO-56 Penman-Monteith (PM FAO-56) model is considered the most accurate, but this model requires a greater amount of meteorological data. On the other hand, there are other methods that require fewer variables and have shown good precision according to the location. The objective of this work was to evaluate the efficiency of four methods for estimation of daily ETo, comparing them with FAO-56 PM equation in Bom Jesus da Lapa, Bahia, Brazil. To do so, a dataset from 2010 to 2017, acquired at the National Institute of Meteorology (INMET), was used. The models were analyzed by means of statistical indicators: Willmott’s concordance index, root mean square error (RMSE), mean bias error (BIAS), coefficient of determination “R²”, correlation coefficient “r” and coefficient of confidence “c”, in addition to the classification of the coefficient of confidence. The results obtained show that Hargreaves and Samani equation was the only method classified as “good” and is recommended. While the models of Camargo, Priestley and Taylor and Benevides and Lopes are not recommended to calculate ETo in the municipality.