27 November 2012 in Nanotechnology
Energy harvesting refers to the set of processes by which useful energy is captured from waste, environmental, or mechanical sources and is converted into a usable form. The discipline of energy harvesting is a broad topic that includes established methods and materials such as photovoltaics and thermoelectrics, as well as more recent technologies that convert mechanical energy, magnetic energy and waste heat to electricity. This article will review various state-of-the-art materials and devices for direct energy conversion and in particular will include multistep energy conversion approaches. The article will highlight the nano-materials science underlying energy harvesting principles and devices, but also include more traditional bulk processes and devices as appropriate and synergistic. Emphasis is placed on device-design innovations that lead to higher efficiency energy harvesting or conversion technologies ranging from the cm/mm-scale down to MEMS/NEMS (micro- and nano-electromechanical systems) devices. Theoretical studies are reviewed, which address transport properties, crystal chemistry, thermodynamic analysis, energy transfer, system efficiency and device operation. New developments in experimental methods; device design and fabrication; nanostructured materials fabrication; materials properties; and device performance measurement techniques are discussed.
24 February 2020 in Physical Review Research
Ultrafast (130-fs) x-ray diffraction at the Linac Coherent Light Source has been applied to observe shock melting, which is driven by a rapid (120-ps) laser pulse impinging on a thin (few micrometers) bilayer of aluminum/zirconium. At a pressure of 100 GPa in the aluminum (130 GPa in the zirconium), there is rapid melting of both metals and the recrystallization of zirconium into the bcc phase. We observe the solidification of the melt starting a few hundred picoseconds following the shock melting, out to 50 ns when the zirconium is fully crystallized into the bcc phase at a residual temperature of approximately 2000 K. The pressure is obtained directly from the early time x-ray data, whereas the additional information from the x-ray line width and intensity at longer times inform a model of crystal nucleation and growth.
1 July 1997 in Physical Review B
We report a joint experimental and theoretical study of the dynamical and structural properties of lead fluoride Specifically, we have performed detailed measurements of the room-temperature Raman-active phonon modes to 310 kbar. We verify the transition at about 4 kbar from the cubic (β) to the orthorhombic (α) phase and the recovery of the α phase at ambient conditions. At approximately 147 kbar, we observe a transformation from the α phase to a modification that we label γ. The data indicate that the γ phase is structurally similar to the orthorhombic α phase. Moreover, we have carried out first-principles calculations which support the existence of a transition in this pressure range, although the crystal structure of the new phase remains undetermined. We have also calculated the equations of state for the two low-pressure phases, β and α. In the case of the α phase, we have made a complete structural determination by calculating the pressure-dependent values of all six internal structural parameters as well as the axial ratios, and , for pressures ranging from zero up to 2 Mbar. Using the calculated α-phase equation of state, we also extract Grüneisen parameters from the data for several optical phonon modes.
16 September 2014 in The Journal of Physical Chemistry A
1 August 2022 in Journal of Applied Physics
The response of rapidly compressed highly oriented pyrolytic graphite (HOPG) normal to its basal plane was investigated at a pressure of ∼80 GPa. Ultrafast x-ray diffraction using ∼100 fs pulses at the Materials Under Extreme Conditions sector of the Linac Coherent Light Source was used to probe the changes in crystal structure resulting from picosecond timescale compression at laser drive energies ranging from 2.5 to 250 mJ. A phase transformation from HOPG to a highly textured hexagonal diamond structure is observed at the highest energy, followed by relaxation to a still highly oriented, but distorted graphite structure following release. We observe the formation of a highly oriented lonsdaleite within 20 ps, subsequent to compression. This suggests that a diffusionless martensitic mechanism may play a fundamental role in phase transition, as speculated in an early work on this system, and more recent static studies of diamonds formed in impact events.
25 January 2021 in Journal of Applied Physics
The availability of pulsed x rays on short timescales has opened up new avenues of research in the physics and chemistry of shocked materials. The continued installation of shock platforms such as gas guns and high power lasers placed at beamline x-ray facilities has advanced our knowledge of materials shocked to extreme conditions of pressure and temperature. In addition, theoretical advancements have made direct correspondence with high-pressure x-ray experiments more viable, increasing the predictive capability of these models. In this paper, we discuss both recent experimental results and the theory and modeling that has been developed to treat these complex situations. Finally, we discuss the impact that new platforms and increased beam time may have on the future direction of this field.