The improved LCL (ILCL) filter is used in transformerless three-level photovoltaic inverter system for leakage current suppression. However, the common-mode (CM) resonance circulating current (CMRCC) is generated, which causes inverter-side current oscillation, leakage current increment and system instability. To overcome these issues, an improved CM circulating current (CMCC) model with detailed analyses of CMRCC is proposed. Based on above theories, the CMRCC is influenced by filter parameters, zero-sequence duty ratio and number of switching transition. To suppress CMRCC, a hybrid control strategy composed of PI and feed-forward control is presented. It is realized by real-time adjusting zero-sequence duty ratio in space vector modulation (SVM) technique. Compared with the conventional damping resistor techniques, the CMRCC and leakage current are effectively suppressed with the proposed method. Thus, the performance of inverter-side currents and leakage current suppression are greatly improved. Besides, the capacitor-voltage-feedforward (CVF) control is adopted to eliminate resonance peak in differential-mode (DM) circuit. Simulation and experimental results are given to demonstrate the effectiveness of theoretical analyses and the proposed method.
1 April 2019 in IEEE Transactions on Industrial Electronics
The conventional three-level inverter only has voltage buck capability. The quasi-Z-source three-level T-type inverter (QZS 3LT $^2$ I) has been proposed to realize voltage buck-boost operation. This paper further proposes a novel modulation scheme for the QZS 3LT $^2$ I to realize voltage boosting, reduce the common-mode voltage (CMV) and control the neutral-point voltage balance simultaneously. The proposed scheme adopts large vector, medium vector, small vector with low CMV magnitude, zero vector, and shoot-through vector to generate the output voltage. According to sector number and neutral-point voltage difference, P-type or N-type small vector with low CMV magnitude is properly selected to balance the neutral-point voltage. Shoot-through states are inserted within zero vector to boost the dc input voltage without affecting the ac output voltage. Dwell times of basic vectors are calculated through the revised volt-second balance equation. Furthermore, a coordinate control strategy between neutral-point voltage balance and voltage boosting is proposed. Doing so, the CMV magnitude can be restricted within one-sixth of dc-link voltage, and neutral-point voltage imbalance can be effectively mitigated. The effectiveness of the proposed scheme are verified by simulations and experiments.
10 July 2020 in IEEE Transactions on Industrial Electronics
The high-frequency zero-sequence circulating current (HFZSCC) is generated when the carrier phases are different in a parallel rectifiers system. Therefore, a modified LCL (MLCL) filter is adopted to suppress the HFZSCC. Nevertheless, the internal common mode resonance current (ICMRC) and external zero-sequence resonance circulating current (EZSRCC) are produced, which causes system instability unavoidably. Since these two issues are coupled with each other, the conventional resonance currents control methods reported so far cannot address them properly simultaneously. To suppress ICMRC and EZSRCC, a detailed model analysis of internal common mode current (ICMC) and zero-sequence circulating current (ZSCC) are presented, which reveal the ICMRC and EZSRCC are related to capacitor-side ZSCC (CSZSCC). Then, based on the model, the controller of CSZSCC is presented to suppress ICMRC and EZSRCC. Additionally, a closed-loop controller is designed to reject disturbances of low-frequency zero-sequence circulating current (LFZSCC). It is realized by adjusting the duty cycle of the small vectors in each PWM sampling period. As a result, HFZSCC, ICMRC, EZSRCC and LFZSCC are mitigated with the proposed scheme thus improving the quality of the input currents. Simulation and experimental results verify the effectiveness of proposed method.