High-entropy alloys (HEAs) are novel solid solution strengthening metallic materials, some of which show attractive mechanical properties. This paper aims to reveal the effect of adding small atomic boron on the interstitial solid solution strengthening ability in the laser cladded CoCrFeNiAlxCu0.7Si0.1By (x = 0.3, x = 2.3, and 0.3 ≤ y ≤ 0.6) HEA coatings. The results show that laser rapid solidification effectively prevents brittle boride precipitation in the designed coatings. The main phase is a simple face-centered cubic (FCC) matrix when the Al content is equal to 0.3. On the other hand, the matrix transforms to single bcc solid solution when x increases to 2.3. Increasing boron content improves the microhardness of the coatings, but leads to a high degree of segregation of Cr and Fe in the interdendritic microstructure. Furthermore, it is worth noting that CoCrFeNiAl0.3Cu0.7Si0.1B0.6 coatings with an FCC matrix and a modulated structure on the nanometer scale exhibit an ultrahigh hardness of 502 HV0.5.
Duplex structure Cu-Cr alloys are widely used as contact materials. They are generally designed by increasing the Cr content for the hardness improvement, which, however, leads to the unfavorable rapid increase of the electrical resistivity. The solidification behavior of Cu100−xCrx (x = 4.2, 25 and 50 in wt.%) alloys prepared by laser rapid solidification is studied here, and their hardness and electrical conductivity after aging are measured. The results show that the Cu-4.2%Cr alloy has the most desirable combination of hardness and conductive properties after aging in comparison with Cu-25%Cr and Cu-50%Cr alloys. Very importantly, a 50% improvement in hardness is achieved with a simultaneous 70% reduction in electrical resistivity. The reason is mainly attributed to the liquid phase separation occurring in the Cu-4.2%Cr alloy, which introduces a large a
Novel high-entropy and medium-entropy stainless steels (MESS), containing a high amount of alloying elements, were designed and prepared by arc melting. These high-entropy and MESS possess a simple phase constitution, mainly solid solution phases, and noticeably exhibit excellent anti-corrosion properties in sulphuric acid. In particular, an austenitic Fe65Cr13Co4.75Mn4.75Mo4.75Ni4.75Cu3 (at.-%) alloy has a higher hardness of 182 HV and better corrosion resistance than those of the 00Cr19Ni14Mn2 austenitic stainless steel prepared under the same condition; a ferritic precipitation hardening Fe65Cr13Al3.167Co3.167Mn3.167Mo3.167Ni3.167Ti3.167Cu3 (at.-%) alloy was also developed, with a higher hardness of 584 HV and even better corrosion resistance.