Stefano Papa

Stefano Papa

Auto-generated profile, based on publicly available information

Stefano Papa

University of Naples Federico II

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
31 March 2026 in Journal of Neural Engineering
Verified
Journal Article
Open access
VRVincenzo Ronca
Vincenzo Ronca
FMFrancesca Massa
Francesca Massa
RARaffaele De Amicis
Raffaele De Amicis
SPStefano Papa
Stefano Papa
LMLuca Mattioli
Luca Mattioli
PAPietro Aricò
Pietro Aricò
Objective: Objective evaluation of operational training is challenging, especially when comparing physical training with virtual reality (VR). Behavioural and subjective measures capture performance and workload but provide limited insight into neurocognitive adaptation. We propose and validate an EEG-derived Cognitive Training Index (CTI) integrating multiple training-sensitive neurometrics to (i) track training progression and (ii) compare VR- versus physical-based training during subsequent real-environment execution. Approach: Participants performed three repetitions of a realistic confined-space industrial maintenance procedure with Entrance, Rolling shutter, and Pipe replacement phases. Execution time, procedural errors, and NASA-TLX were collected after each trial. Wearable EEG was recorded continuously; six neurometrics were computed from cleaned EEG using band-specific Global Field Power over predefined electrode sets. CTI was obtained via Principal Component Analysis at trial level, then analysed segment-wise. Temporal specificity was tested with phase-randomized surrogate analyses. Main results: Execution time decreased across trials (F = 14.82, p < .001, η²p = 0.35), errors decreased (F = 10.31, p < .001, η²p = 0.27), and NASA-TLX declined (F = 11.94, p < .001, η²p = 0.30). CTI increased with training (F = 18.21, p < .001, η²p = 0.39) and was higher in learning-relevant phases (Entrance and Pipe replacement) while remaining near baseline in Rolling shutter; surrogate analyses confirmed CTI exceeded null expectations. Repeated-measures correlations linked higher CTI to fewer errors (R = −0.42, p < .01) and lower NASA-TLX (R = −0.38, p < .01), with no association with execution time (R = 0.18, p = .12). Significance: CTI provides a psychologically grounded, multivariate EEG marker that tracks training progression and aligns with operationally meaningful outcomes (accuracy and perceived workload) rather than speed, enabling objective comparison of cognitive adaptation across training modalities.

7 April 2025 in IEEE Journal of Oceanic Engineering
Verified
Journal Article
Closed access
RBRomolo Di Bernardo
Romolo Di Bernardo
Antonio GloriaAntonio Gloria
Antonio Gloria
SPStefano Papa
Stefano Papa
Domenico SperanzaDomenico Speranza
Domenico Speranza
In recent years, maritime industries have focused their attention on hydrofoils as one of the main technologies for the development of eco-sustainable solutions in the field of boating. The aim of the current research was to analyze the front wing of a Kohlkida class hydrofoil and to describe the methodology employed for the reconstruction of the 2-D airfoils by means of photogrammetry. Considering the limitations of the photogrammetry methods, some sections were extracted from the model. The airfoils were properly scaled and first compared with the model obtained by means of a laser scanner. Under the operating condition of the hydrofoil and with the use of Reynolds-averaged Navier–Stokes simulations, the behavior of the airfoils was simulated, allowing us to verify how the geometric differences due to the photogrammetry approach affect the fluid dynamics, in comparison to the model obtained from laser scanning. The proposed methodology led to a geometry reconstruction with adequate accuracy for the identification of both the characteristic curves for the lift and drag coefficients with a maximum error of 6% in the angle-of-attack range investigated in the study, also highlighting fluid dynamics problems that characterize this type of airfoils with a flat bottom and a knife-sharp leading edge.

25 September 2022
Verified
Book Chapter
Closed access
PDF file
Domenico SperanzaDomenico Speranza
Domenico Speranza
RBRomolo Di Bernardo
Romolo Di Bernardo
Massimo MartorelliMassimo Martorelli
Massimo Martorelli
Antonio GloriaAntonio Gloria
Antonio Gloria
CPClaudio Pensa
Claudio Pensa
SPStefano Papa
Stefano Papa


18 January 2023 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
Verified
Journal Article
Closed access
FBFelicia Carla Tiziana Barbato
Felicia Carla Tiziana Barbato
AAA. Abba
A. Abba
AAA. Anastasio
A. Anastasio
GBG. Barbarino
G. Barbarino
ABA. Boiano
A. Boiano
LWL. Wu
L. Wu

12 October 2020 in International Journal on Interactive Design and Manufacturing (IJIDeM)
Verified
Journal Article
Open access
PDF file
FRFabrizio Renno
Fabrizio Renno
FBF. Barbato
F. Barbato
GBG. Barbarino
G. Barbarino
DMDomenico Marzullo
Domenico Marzullo
RGR. Guida
R. Guida
SPS. Papa
S. Papa
Main targets of this activity research are the making and the optimization of new detectors by means of the Systems Engineering methods. With the observation of the gravitational wave event of August 17th, 2017 and then with those of the extragalactic neutrino of September 22nd, the Multimessenger Astrophysics era began. It is a new way of exploring the Universe, powered by globally coordinated observations of several experiments. So, new X and gamma rays’ detectors solutions are needed in order to provide competitive results in the energy range 10 keV–10 meV. Here is briefly described how the Systems Engineering can improve the development of the proposal of a new technique: The Crystal Eye, a wide field of view detector with a good spatial resolution obtained thanks to a high pixelation.