16 May 2023 in Nature Communications
Real-time monitoring of flow turbulence is very difficult but extremely important in fluid dynamics, which plays an important role in flight safety and control. Turbulence can cause airflow to detach at the end of the wings, potentially resulting in the aerodynamic stall of aircraft and causing flight accidents. Here, we developed a lightweight and conformable system on the wing surface of aircraft for stall sensing. Quantitative data about airflow turbulence and the degree of boundary layer separation are provided in situ using conjunct signals provided by both triboelectric and piezoelectric effects. Thus, the system can visualize and directly measure the airflow detaching process on the airfoil, and senses the degree of airflow separation during and after a stall for large aircraft and unmanned aerial vehicles.
1 November 2021 in Colloids and Surfaces B: Biointerfaces
1 January 2023 in Physics of Fluids
The application of drag reduction tech holds great significance to energy saving. To achieve better drag reduction, we investigated the flow characteristics of the turbulent boundary layer (TBL) over a composite surface made of sawtooth riblets with superhydrophobic coat (rib&SHS), a superhydrophobic surface (SHS), and a smooth surface using particle image velocimetry. The results showed that the drag reduction rate of the composite surface was higher than that of the superhydrophobic surface at the same Reynolds number. When the Reynolds number reached 2015, the drag reduction effect of SHS was almost ineffective (drag reduction was only 1.2%), whereas rib&SHS maintained satisfactory results (drag reduction was 20.2%). By proper orthogonal decomposition (POD), the second-order POD mode showed the tilt angles of the interface of Q2 and Q4 events inside the TBL over rib&SHS, and SHS were reduced compared with the smooth surface in the drag reduction cases. With drag reduction of rib&SHS and SHS, the hairpin vortexes were lifted away from the wall and the distances of vortexes within hairpin vortex packets decreased. Compared with SHS, rib&SHS had a greater effect on hairpin vortexes and hairpin vortex packets because the riblets made the Q2 events of rib&SHS weaker than that of SHS. So, the rib&SHS has a higher drag reduction rate and a larger drag reduction Reynolds number range than the SHS. It can be used to guide the drag reduction design of underwater vehicles.
1 February 2022 in Chemical Engineering Science
29 October 2022 in iScience
Energy harvesting technologies that convert fluid energy into usable electrical energy are of great significance, especially in long-distance pipeline systems. Here, in order to avoid the collision of conventional galloping triboelectric nanogenerators (GTENGs), and cause material damage or noise, a freestanding gallop-based triboelectric-piezoelectric hybrid nanogenerator (HG P-TENG) is proposed to reduce material wear and improve the reliability of GTENG. Two piezoelectric sheets are attached to the cantilever beam. The root-mean-square (RMS) and peak output power of the HG P-TENG are 68.9 μW and 1.27 mW, respectively. To improve the harvesting efficiency, the fixed copper electrodes are segmented, and experiments indicate that this way of segmenting electrodes can improve the energy harvesting efficiency. Finer electrodes can effectively increase the charging rate of capacitors. A self-powered thermohygrometer and light-emitting diodes (LEDs) are demonstrated in the wind tunnel. It demonstrates that the proposed hybrid nanogenerator will exhibit great potential in pipeline systems.
1 November 2021 in Energy Reports