Caglar Ozdag

Caglar Ozdag

Auto-generated profile, based on publicly available information

Caglar Ozdag

IBM Thomas J. Watson Research Center, Yorktown Heights, NY, USA

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 September 2022 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
BSBodhisatwa Sadhu
Bodhisatwa Sadhu
APArun Paidimarri
Arun Paidimarri
DLDuixian Liu
Duixian Liu
MYMark Yeck
Mark Yeck
COCaglar Ozdag
Caglar Ozdag
AVAlberto Valdes-Garcia
Alberto Valdes-Garcia
We present a 24–30-GHz 256-element dual-polarization transceiver (TRX) phased array based on a 16-element beamformer integrated circuit (BF-IC), 2-element frequency conversion integrated circuit (FC-IC), liquid crystal polymer (LCP)-based combiners and filters, and a tileable package with 64 embedded dual-polarized (dual-pol) antennas. The phased array presented in this work overcomes three key challenges in current 5G millimeter-wave (mmWave) antenna arrays: 1) it supports a dramatic increase in the number of supported fast-access beams; 2) it offers improved power efficiency; and 3) it provides a path to lower solution cost. 1) We enable fast switching among $>$ 30 000 beams—orders of magnitude improvement over prior work—by employing an on-chip beam calculator in the BF-IC, achieving 200-ns beam setup and 8-ns over-the-air (OTA)-switching time. 2) We enable a module-level transmitter (TX) mode peak power added efficiency (PAE) of 20% using a modular architecture that preserves power amplifier (PA) linearity and efficiency as well as receiver (RX) mode low noise amplifier (LNA) noise figure (NF). The module achieves Psat effective isotropically radiated power (EIRP) of 68.5 dBm and BF-IC NF $<$ 3.9 dB. 3) We lower the solution cost by enabling a wider steering range to reduce the number of phased arrays required in a sectorized coverage scheme, by reducing the IC and package area, and by avoiding calibration. The wider steering range is enabled by using an in-package magnetoelectric dipole antenna (for the first time in silicon-based phased arrays), resulting in steering over $\pm$ 70 $^\circ$ in H-and V-pol in both E-and H-planes without requiring any calibration. Moreover, the module achieves $>$ 20-dB cross-polarization isolation across the entire $\pm$ 70 $^\circ$ beam steering range.

14 August 2018 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
WLWooram Lee
Wooram Lee
JPJean-Olivier Plouchart
Jean-Olivier Plouchart
COCaglar Ozdag
Caglar Ozdag
YAYigit Aydogan
Yigit Aydogan
MYMark Yeck
Mark Yeck
AVAlberto Valdes-Garcia
Alberto Valdes-Garcia
94-GHz dual-polarized phased array transmitter and receiver ICs in 130 nm BiCMOS technology are reported. The transmitter IC integrates 16 transmitter front ends with two independent outputs, a 1-to-16 power splitter, and an intermediate frequency (IF)-to-RF up-converter. The receiver IC integrates 32 front ends, two separate 16-to-1 power combiners, and two RF-to-IF down-converters, which can either support a 32-element phased array or a 16-element polarimetric phased array if connected to 16 dual-polarized antennas. Both transmitter and receiver ICs include IF/baseband circuitry, a frequency synthesizer with continuous lock detection, a temperature sensor, and digital circuitry, including serial interface and front-end memory. On-wafer TX measurements at 94 GHz taken at 25 °C show an IF-to-RF conversion gain of 35 dB, oP1dB of 4 dBm, $P_{\text {SAT}}$ of 7.8 dBm per channel with a total power consumption of 3 W. On-wafer RX measurements at 94 GHz and 25 °C show a maximum RF-to-IF array conversion gain of 40 dB and an noise figure (NF) of 6 dB. The total RX power consumption varies from 3 to 4.6 W as it is configured from its minimum to its maximum RF front-end gain settings. RF phase shifting elements used in both TX and RX demonstrate a 1.6° phase resolution with 360° tuning range and gain variation (rms) lower than 0.5 dB. Phase-invariant gain tunability in TX and RX front ends has been achieved for independent tapering and beam steering, demonstrating the measured phase variation within ±0.5° for 10-dB gain tuning. Both TX and RX ICs are functional up to 105 °C, maintaining $P_{\text {SAT}}>6.5$ dBm per channel in TX and NF < 12 dB in RX. The TX and RX ICs each have a chip size of 6.7 mm $\times $ 5.6 mm.

3 April 2024 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
WLWooram Lee
Wooram Lee
COCaglar Ozdag
Caglar Ozdag
JPJean-Olivier Plouchart
Jean-Olivier Plouchart
AVAlberto Valdes-Garcia
Alberto Valdes-Garcia
BSBodhisatwa Sadhu
Bodhisatwa Sadhu
This article presents a compact 24–30-GHz phased array transceiver (TRX) front end (FE) with high transmitter (TX) power efficiency and low receiver (RX) noise figure (NF) in a 130-nm bipolar CMOS (BiCMOS) technology supporting different 5th generation mobile network (5G) frequency range 2 (FR2) bands (n257, n258, and n261). We introduce an embedded antenna TX/RX (T/R) switch (SW) topology to co-optimize the performances of the power amplifier (PA) and the low-noise amplifier (LNA) while minimizing insertion loss and die area. The proposed TRX integrated circuits (ICs) also integrates a transmission line-based passive phase shifter and 1-bit phase inverter for phase control and a phase-invariant variable gain amplifier (VGA) for gain control, enabling orthogonal phase and gain control in the FE. On-wafer measurements of the TRX FE IC at 25 °C demonstrate TX mode peak power efficiency of 22%–24% and RX-mode NF of 2.8–3.1 dB, including the impact of the antenna T/R switch. The measured OP1dB and $P_{\mathrm{ SAT}}$ in the TX mode are 15.6–16.2 and 17.8–18.8 dBm, respectively. RF phase shifting measurements demonstrate < 5.6° phase resolution with gain variation lower than ±0.5 dB without the need for calibration. We implement phase-invariant gain tunability for orthogonal tapering and beam steering control; the measured phase variation is ${ < }\pm 1.5^{\circ} $ for 8-dB gain tuning over 24–30 GHz. The IC was measured at a temperature up to 105 °C and maintains TX peak power efficiency > 19% with $P_{\mathrm{ SAT}}$ degradation < 1 dB and RX NF < 5.1 dB. The IC has an active area of 2.1 $\times $ 0.6 mm.

28 October 2024 in IEEE Open Journal of the Solid-State Circuits Society
Verified
Journal Article
Open access
APArun Paidimarri
Arun Paidimarri
YTYujiro Tojo
Yujiro Tojo
COCaglar Ozdag
Caglar Ozdag
AVAlberto Valdes-Garcia
Alberto Valdes-Garcia
BSBodhisatwa Sadhu
Bodhisatwa Sadhu
The wireless spectrum is a shared resource. Transmitters are expected to transmit only at their allotted frequency range and not at other frequencies. Transmitters are not perfect, and therefore, there are regulations that limit the transmitted energy outside the intended transmission frequencies. In this paper, we provide an overview of the transmit mask requirements for 5G FR2, and the main factors that contribute to unwanted emissions. We then present some key radio architecture and circuit design considerations to help meeting these emission requirements. Since the local oscillator (LO) leakage spur is one of the worst offenders, we also introduce an LO cancellation technique in the up-mixer. We introduce two actuator circuits to control two independent LO signals at the up-mixer output, one resulting from the up-conversion from DC to LO, and another resulting from down-conversion from 2LO to LO. These two independent LO outputs then provide 2-dimensional phase and amplitude control and can combine to create an equal and opposite LO signal at the output of the up-mixer. The LO cancellation results in better than..57 dBc LO leakage across all candidate frequencies. Finally, we present extensive over-the-air (OTA) measurement validation of the LO suppression across frequencies, signal levels, and 64-element beam steering across a ±60∘ beam steering range.

4 February 2025 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
COCaglar Ozdag
Caglar Ozdag
APArun Paidimarri
Arun Paidimarri
MYMasayuki Yoshiyama
Masayuki Yoshiyama
YYYuichiro Yamaguchi
Yuichiro Yamaguchi
YTYujiro Tojo
Yujiro Tojo
BSBodhisatwa Sadhu
Bodhisatwa Sadhu
A 21–27-GHz frequency quadrupler in the 0.13-μm SiGe BiCMOS technology with the 0-dBm output power (POUT) and 40-dBc harmonic rejection ratio (HRR) is presented. A method for load—pull-based output network design is introduced to co-optimize HRR and POUT; as a result, the design achieves flat and high HRR and POUT across 25% bandwidth and a wide input power (PIN) range. This article also discusses the quadrupler’s POUT and HRR specifications in the context of its integration within a phased-array antenna module (PAAM). We designed two versions of the 64-element wideband 5G phased-array PAAM, one including and one excluding the quadrupler, to demonstrate the minimal impact of the quadrupler on the output spectrum. We also measure the spur performance in dual-polarization mode to evaluate cross-polarization spurs. The spurious emissions across POUT range of the phased array is better than -20 dBm/MHz, well below the 3GPP 5G FR2 limit of -15 dBm/MHz. The quadrupler design has the highest HRR performance reported among wideband mmWave quadruplers and thoroughly demonstrates, for the first time, the impact of the local oscillator (LO) frequency multiplier on the performance of a wideband phased-array system.