15 February 2022 in Journal of the American Chemical Society
16 February 2021 in Nature Communications
Water is the only available fossil-free source of hydrogen. Splitting water electrochemically is among the most used techniques, however, it accounts for only 4% of global hydrogen production. One of the reasons is the high cost and low performance of catalysts promoting the oxygen evolution reaction (OER). Here, we report a highly efficient catalyst in acid, that is, solid-solution Ru‒Ir nanosized-coral (RuIr-NC) consisting of 3 nm-thick sheets with only 6 at.% Ir. Among OER catalysts, RuIr-NC shows the highest intrinsic activity and stability. A home-made overall water splitting cell using RuIr-NC as both electrodes can reach 10 mA cm−2geo at 1.485 V for 120 h without noticeable degradation, which outperforms known cells. Operando spectroscopy and atomic-resolution electron microscopy indicate that the high-performance results from the ability of the preferentially exposed {0001} facets to resist the formation of dissolvable metal oxides and to transform ephemeral Ru into a long-lived catalyst.
14 May 2021 in ACS Applied Materials & Interfaces
The hydrogen storage capacity of Pd nanoparticles (NPs) decreases as the particles become smaller; however, this reduced capacity is ameliorated by addition of Pt. In the present work, the hydrogen storage mechanism and structural transformations of core (Pd)–shell (Pt) (CS) and solid-solution (SS) NPs during hydrogen absorption and desorption (PHAD) processes are investigated. In situ X-ray absorption spectroscopy measurements were performed to study the evolution of electronic and local structures around Pd and Pt during PHAD. Under ambient conditions, Pd and Pt have distinct local structures. The Pd atomic pairs are more strained in CS NPs than in SS NPs. A similar behavior has been seen in CS NPs after PHAD. The Pd K-edge extended X-ray absorption fine structure data indicate that in CS and SS NPs a substantial fraction of the signal derives from Pd–Pd atomic pairs, indicating that Pd clusters remain present even after PHAD. PHAD causes a rearrangement of the interfacial structure, which becomes homogeneously distributed. The higher coverage of active bimetallic sites results in a higher observed hydrogen storage capacity in the SS phase.
15 November 2021 in ACS Materials Au
The crystal structure, which intrinsically affects the properties of solids, is determined by the constituent elements and composition of solids. Therefore, it cannot be easily controlled beyond the phase diagram because of thermodynamic limitations. Here, we demonstrate the first example of controlling the crystal structures of a solid-solution nanoparticle (NP) entirely without changing its composition and size. We synthesized face-centered cubic (fcc) or hexagonal close-packed (hcp) structured PdxRu1–x NPs (x = 0.4, 0.5, and 0.6), although they cannot be synthesized as bulk materials. Crystal-structure control greatly improves the catalytic properties; that is, the hcp-PdxRu1–x NPs exceed their fcc counterparts toward the oxygen evolution reaction (OER) in corrosive acid. These NPs only require an overpotential (η) of 200 mV at 10 mA cm–2, can maintain the activity for more than 20 h, greatly outperforming the fcc-Pd0.4Ru0.6 NPs (η = 280 mV, 9 min), and are among the most efficient OER catalysts reported. Synchrotron X-ray-based spectroscopy, atomic-resolution electron microscopy, and density functional theory (DFT) calculations suggest that the enhanced OER performance of hcp-PdRu originates from the high stability against oxidative dissolution.
25 August 2023 in Journal of Applied Crystallography
17 October 2023 in Journal of Synchrotron Radiation
The spatial resolution in scanning-based two-dimensional microscopy is normally limited by the size of the probe, thereby a smaller probe is a prerequisite for enhancing the spatial resolution. For three-dimensional microscopy that combines translation and rotation motions of a specimen, however, complex trajectories of the probe highly overlap in the specimen, which could change the postulate above. Here, the spatial resolution achieved in scanning three-dimensional X-ray diffraction (s3DXRD) microscopy is investigated. In this method, the most appropriate orientation of the pixel in the specimen coordinate is selected by comparing the completeness of diffraction peaks with theory. Therefore, the superposed area of the beam trajectory has a strong effect on the spatial resolution, in terms of the completeness of diffraction peaks. It was found that the highly superposed area by the incident X-rays, which has the highest completeness factor in the pixel of the specimen, is much smaller than the X-ray probe size, and that sub-pixel analysis by dividing a pixel into small pieces leads to drastic improvement of the spatial resolution in s3DXRD.