The change of the morphology and indium distribution in an quantum well embedded in GaN was investigated depending on the duration of electron-beam irradiation in a transmission electron microscope. Strain-state analysis based on high-resolution lattice-fringe images was used to determine quantitatively the local and average indium concentration of the InGaN quantum well. In-rich clusters were found already in the first image taken after 20 s of irradiation. The indium concentration in the clusters tends to increase with prolonged irradiation time. In contrast, the locally averaged indium concentration and the quantum-well width do not change within the first minute.
The influence of different growth conditions on the In distribution in ultrathin InGaN insertions in a GaN matrix is investigated by high-resolution transmission electron microscopy and an appropriate image evaluation technique. It is demonstrated that the indium distribution represents dense arrays of In-rich nanodomains inserted in a layer with a lower indium concentration. The sizes of the In-rich regions are about 4–5 nm at a growth temperature of 720 °C. Increasing the growth temperature leads to a strong decrease in the of nanoisland density and, also, a moderate decrease in their lateral size. Increasing the trimethylindium/trimethylgallium ratio strongly increases the density of the islands, but the lateral size remains weakly effected. The observations are in agreement with a thermodynamic model of island formation including entropy effects.
The structure of the fiber –matrix interface region of carbon-fiber/carbon-matrix (C/C)-composites, which is important for the mechanical properties of a composite, was studied by transmission electron microscopy. The pyrolytic carbon matrix was obtained by chemical vapor infiltration of carbon fiber preforms with different fiber architecture and fiber types. While the texture of the carbon matrix can be controlled by the infiltration conditions, the carbon texture at the fiber –matrix interface differs from the bulk matrix and cannot be determined by the infiltration parameters. We often observe a high-textured layer with a thickness up to 100 nm at the interface prior to the formation of the bulk matrix with a lower texture. The fiber –matrix interface properties of C/C-composites are compared with the interface of pyrolytic carbon layers deposited on planar Si-, BN- and cordierite-substrates. In contrast to BN-substrates, thin high-textured pyrolytic layers are observed at the interface of carbon on planar Si- and cordierite-substrates where strong bonding between pyrolytic carbon and the substrate is achieved by the formation of Si-C bonds. Stress-induced ordering is discussed as a mechanism for the formation of the high-textured interface layers.