18 March 2002 in Applied Physics Letters
The influence of different growth conditions on the In distribution in ultrathin InGaN insertions in a GaN matrix is investigated by high-resolution transmission electron microscopy and an appropriate image evaluation technique. It is demonstrated that the indium distribution represents dense arrays of In-rich nanodomains inserted in a layer with a lower indium concentration. The sizes of the In-rich regions are about 4–5 nm at a growth temperature of 720 °C. Increasing the growth temperature leads to a strong decrease in the of nanoisland density and, also, a moderate decrease in their lateral size. Increasing the trimethylindium/trimethylgallium ratio strongly increases the density of the islands, but the lateral size remains weakly effected. The observations are in agreement with a thermodynamic model of island formation including entropy effects.
11 July 2009 in Semiconductors
Magnesium is the only acceptor impurity practically used in MOCVD of GaN. High activation energy requires high impurity concentration, which results in epilayer morphology degradation. In the presented paper an influence of growth regimes, including choice of carrier gas, on GaN:Mg morphology is presented. It is demonstrated that surface morphology depends on an average magnesium concentration and strongly improves with using nitrogen as carrier gas.
28 November 2001 in Nanotechnology
The first successful results of the application of multifractal analysis to a quantitative description of mosaic-structure peculiarities, that are typical of a GaN epitaxial layer with hexagonal modification grown on (0001) sapphire substrates, have been obtained. The characteristic size of the mosaic structure has been measured to be 200-800 nm. The direct dependence of mobility on the multifractal parameters (the Renyi dimension or the self-organization degree and the order-degree index) of the surface topology of the mosaic structure has been observed for all GaN layers investigated.
9 November 1999 in Physica Status Solidi (b)
21 June 1999 in Applied Physics Letters
We report surface-mode lasing in a structure with 12-fold stacked InGaN insertions in a GaN matrix without using of Bragg mirrors. At high excitation densities, one of the modes of the Fabry–Perot cavity formed by the GaN sapphire and the GaN air interfaces, shows a strong superlinear increase in intensity with excitation density rise. The possibility to reach surface lasing in a very low finesse microcavity is due to the ultrahigh material gain of the InGaN insertions. The strong modulation of the absorption-gain spectrum with increase in the excitation density results in a pronounced energy shift of the cavity modes. We found that the threshold excitation density is weakly affected by temperature up to 110 K, while increases at higher temperatures. This behavior is attributed to thermal evaporation of carriers from InN-rich nanodomains and is typical for quantum dot lasers.
1 March 2012 in Technical Physics Letters
A light-emitting diode (LED) structure based on group III nitride has been grown for the first time on Si(111) substrate with SiC buffer nanolayer (50- to 200-nm-thick) obtained by solid-phase epitaxy. This LED structure is characterized by record low (<108 cm−2) density of lattice misfit dislocations at a total dislocation density of ∼8 × 108 cm−2. The photo- and electroluminescence spectra of obtained structures have been measured.