29 August 2023 in Mechanics of Advanced Materials and Structures
20 January 2023 in PLOS ONE
ASAhmad Abdullah Saifizul
The inerter is a two-terminal component that can be added to the spring-and-damper configuration of a suspension system. It has the property that the force exerted is proportional to the relative acceleration at its terminals. Studies have demonstrated the inerter’s benefit of providing superior vibration isolation when it is used in the vehicle suspension of passenger cars. However, similar benefit on another common vehicle class on the roads, namely heavy vehicles, remain to be shown, as these vehicles have vastly different parameter values than passenger cars. This study is an investigation on the performance improvement brought by an inerter in the suspension of common heavy vehicles. In the study, the parameter values of a truck and a bus were adopted in the quarter vehicle model with two different spring-damper-inerter configurations (parallel and serial inerter), and the improvements in vibration isolation and road holding capability were determined by optimization of inertance. Results show that the inerter is similarly effective in providing the said improvements when implemented on heavy vehicles instead of on passenger cars, judging from reductions in sprung mass acceleration and dynamic tire load. It is also observed that the performance benefit is associated with larger optimum inertance than that for passenger cars. Overall, the inerter has been shown to be beneficial in the parallel and serial configurations, both of which are common and can be practically implemented in the suspension of heavy vehicles.
29 October 2021 in Smart Materials and Structures
In recent years, harnessing electrical energy from mechanical vibration by using a piezoelectric energy harvester (PEH) has attracted much attention from researchers. This sustainable energy harvester is useful for wireless sensor network, where a replacement or replenishment of an energy source such as a battery is impractical. From previous studies, the amount of energy generated by the PEH is very limited even in a high force environment. To solve this issue, mechanical amplifier structure such as Cymbal structure is implemented to amplify the tensile loading force towards the PEH. In terms of the material strength perspective, this performance can be further enhanced by using a compressive-type mechanical amplifier structure, as the compressive yield strength of piezoelectric material is much higher than its tensile yield strength. In this study, a compressive structural design which is named as Hull structure is proposed. Several techniques included analytical model analysis, finite element analysis (FEA), and experimental testing have been used to evaluate its performance. It shows a force amplification factor of 9.72 at 6° through the analytical model. From the FEA result, the proposed Hull structure shows great potential in enhancing the power output of 11.34 mW, which is 3.08 times larger than the benchmarking Tensile Cymbal structure. It also shows 5.28 times greater output voltage than the benchmark case in the experiment. Besides, it has a great advantage of providing a wider area for excitation loading force which increases the PEH’s load capacity and suitable for the vehicular excitation application.
16 May 2025 in Alexandria Engineering Journal