Shuangquan Ran

Shuangquan Ran

Auto-generated profile, based on publicly available information

Shuangquan Ran

State Key Laboratory of Dynamic Testing Technology, North University of China, Taiyuan, China

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 September 2024 in IEEE Sensors Journal
Verified
Journal Article
Closed access
SRShuangquan Ran
Shuangquan Ran
KHKun Huang
Kun Huang
XMXiaobiao Mao
Xiaobiao Mao
GRGuihao Ran
Guihao Ran
QHQin Hu
Qin Hu
THTao Hu
Tao Hu
High-precision quantum sensing techniques based on diamond nitrogen vacancy (NV) centers have been widely used in many industries. The quantum precision measurement schemes based on NV centers have been continuously reported in recent years. However, there is still a gap in research on non-contact torque measurement applied to common steel shaft materials. Therefore, in this paper, an integrated non-contact torque sensor based on diamond nitrogen vacancy (NV) centers is proposed. The magnetic flux gathering module, microwave (MW) antenna, light path system, fluorescence acquisition module, amplification and filtering circuitry (AAFC), copper coil, and power conversion circuitry were integrated into the torque sensor, with a volume of approximately 33.18 cm 3 . In our work, infinite gain multiple feedback amplification filter circuits had been used to improve the signal quality and magnetic flux aggregation modules to improve the detection sensitivity of the system. The ellipsoidal light gathering cavity was used to enhance the fluorescence utilization. The magnetoelastic effect of ferromagnetic materials had been combined to realize the non-contact trial measurement of ordinary steel shafts (with low magnetostriction coefficient). Subsequently, the noise sensitivity of the torque sensor of about 36.218 nNm/Hz 1/2 was verified. This new torque sensor has a high magnetic spatial sensitivity and can therefore be used for torque detection of bearings in a wide range of ferromagnetic materials with low magnetostrictive coefficients.