Gas transport parameters and X-ray computed tomography (CT) measurements in porous medium under controlled and identical conditions provide a useful methodology for studying the relationships among them, ultimately leading to a better understanding of subsurface gaseous transport and other soil physical processes. The objective of this study was to characterize the relationships between gas transport parameters and soil-pore geometry revealed by X-ray CT. Sands of different shapes with a mean particle diameter (d50) ranging from 0.19 to 1.51 mm were used as porous media under both air-dried and partially saturated conditions. Gas transport parameters including gas dispersivity (α), diffusivity (DP/D0), and permeability (ka) were measured using a unified measurement system (UMS). The 3DMA-Rock computational package was used for analysis of three-dimensional CT data. A strong linear relationship was found between α and tortuosity calculated from gas transport parameters ( JOURNAL/sosc/04.02/00010694-201302000-00002/math_2MM1/v/2017-12-29T203917Z/r/image-tiff ), indicating that gas dispersivity has a linear and inverse relationship with gas diffusivity. A linear relationship was also found between ka and d50/TUMS2, indicating a strong dependency of ka on mean particle size and direct correlation with gas diffusivity. Tortuosity (TMFX) and equivalent pore diameter (deq.MFX) analyzed from microfocus X-ray CT increased linearly with increasing d50 for both Granusil and Accusand and further showing no effect of particle shape. The TUMS values showed reasonably good agreement with TMFX values. The ka showed a strong relationship when plotted against deq.MFX/TMFX2, indicating its strong dependency on pore size distribution and tortuosity of pore space.
Cool road pavements contribute to mitigating urban heat islands. To evaluate the heat balance in paved surfaces and to select appropriate road construction materials that help suppress heat islands, an accurate understanding of heat transport parameters such as thermal conductivity (λ) and heat capacity (HC) is important. Recycled aggregates from construction and demolition waste, including scrap construction materials and industrial by-products, are often used for road construction; however, λ and HC of recycled aggregates especially for roadbeds are not fully understood. This study involved a series of laboratory tests to measure λ and HC of recycled concrete and clay brick aggregates (<40 mm) and their mixtures with autoclaved aerated concrete grains (<2 mm) under varied moisture conditions. The measured λ and HC increased with increasing volumetric water content (θ). Closed-form models for estimating λ(θ) were proposed using normalized thermal conductivity (λe) and effective saturation (Se). The new λe(Se) models performed well for the measured data compared to previously proposed models and would be useful to evaluate λ of recycled aggregates for roadbed materials.
18 February 2022 in Geomechanics for Energy and the Environment
This study demonstrates the ability of the Rayleigh-based phase-noise compensated optical frequency-domain reflectometry (PNC-OFDR) sensing method to monitor the distributed temperature field with an ultra-short data acquisition period of 2 ms, a spatial resolution of 2 cm, and a temperature resolution of 0.1 °C. A heating cable (H-cable) was embedded within a cylindrical concrete mortar specimen and subjected to various heating powers. A sensing optical cable (temperature measurement cable) was placed adjacent to the H-cable to monitor the temperature distribution continuously. Two water-holding boxes were installed along the specimen at two positions to retain water. The study’s results indicated that the PNC-OFDR technique demonstrated a high sensitivity to even small temperature changes, enabling it to pinpoint water locations at two distinct points accurately. The research determined the minimal heating power required to successfully locate the water positions. The magnitude of the heating power exerted a significant impact on the temperature change. Three distinct phases of temperature increment were observed for a given heating period: rapid, fast, and gentle increase. The insights gained from this study have the potential to be applied in natural fields, allowing for the detection of groundwater and seepage phenomena in vulnerable slopes.