21 September 2018 in Biomacromolecules
7 March 2019 in Scientific Reports
The aim of the present study was to investigate the additive manufacturing process for high consistency nanocellulose. Unlike thermoformable plastics, wood derived nanocelluloses are typically processed as aqueous dispersions because they are not melt-processable on their own. The ability to use nanocellulose directly in additive manufacturing broadens the possibilities regarding usable raw materials and achievable properties thereof. Modern additive manufacturing systems are capable of depositing nanocellulose with micrometer precision, which enables the printing of accurate three-dimensional wet structures. Typically, these wet structures are produced from dilute aqueous fibrillar dispersions. As a consequence of the high water content, the structures deform and shrink during drying unless the constructs are freeze-dried. While freeze-drying preserves the geometry, it results in high porosity which manifests as poor mechanical and barrier properties. Herein, we study an additive manufacturing process for high consistency enzymatically fibrillated cellulose nanofibers in terms of printability, shape retention, structure, and mechanical properties. Particular emphasis is placed on quantitative shape analysis based on 3D scanning, point cloud analysis, and x-ray microtomography. Despite substantial volumetric as well as anisotropic deformation, we demonstrate repeatability of the printed construct and its properties.
17 July 2018 in ACS Applied Materials & Interfaces
A continuous and scalable method for wet-spinning of cellulose nanofibrils (CNF) is introduced in a core/shell configuration. Control on the interfacial interactions was possible by the choice of the shell material and coagulant, as demonstrated here with guar gum (GG) and cellulose acetate (CA). Upon coagulation in acetone, ethanol or water, GG and CA formed supporting polymer shells that interacted to different degrees with the CNF core. Coagulation speed was shown to markedly influence the CNF orientation in the filament and, as a result, its mechanical strength. The fastest coagulation noted for the CNF/GG core/shell system in acetone led to an orientation index of ~0.55 (Herman’s orientation parameter of 0.40), Young’s modulus of ~2.1 GPa, tensile strength of ~70 MPa and tenacity of ~8 cN/tex. The system that underwent the slowest coagulation rate (CNF/GG in ethanol), displayed a limited CNF orientation but achieved an intermediate level of mechanical resistance, owing to the strong core/shell interfacial affinity. By using CA as the supporting shell, it was possible to spin CNF into filaments with high water absorption capacity (43 g water/g dry filament). This was explained by the fact that water (used as coagulant for CA) limited the densification of the CNF core structure, yielding filaments with high accessible area and pore density.
10 September 2018 in ACS Omega
We developed a spinning approach for a dope produced by treating softwood pulp with a deep eutectic solvent (DES). The DES enables formation of a sufficiently viscous spinnable gel-like suspension of fibers, which solidifies upon the removal of the DES. This solidification, however, requires a longer time compared to most conventional wet spinning processes. Consequently, the continuity of the spinning process has been constrained in previous work. Moreover, the ability to draw the incipient yarn to increase orientation has been limited. Here we present a continuous spinning approach where the fiber yarn properties and processability can be improved using an inclined channel. A combination of an air gap and an inclined ethanol stream transports and draws the incipient fiber yarn during spinning. The influence of syringe tip diameter, angle of the channel, ethanol flow rate, and twisting were studied experimentally. The improvements in the spinning process resulted in an increase in load bearing capability and ability to reduce the linear density of the fiber yarn.
24 January 2020 in Scientific Reports
An amendment to this paper has been published and can be accessed via a link at the top of the paper.