Aeroelastic energy harvesting can be used to power wireless sensors embedded into bridges, ducts, high-altitude buildings, etc. One challenging issue is that the wind speed in some application environments is low, which leads to an inefficiency of aeroelastic energy harvesters. This paper presents a novel nonlinear magnetic-coupled flutter-based aeroelastic energy harvester (FAEH) to enhance energy harvesting at low wind speeds. The presented harvester mainly consists of a piezoelectric beam, a two-dimensional airfoil, two tip magnets and two external magnets. The function of magnets is to reduce the cut-in wind speed of the FAEH and enhance energy harvesting performance at low wind speeds. A theoretical model is deduced based on Hamilton’s principle, theory of aeroelasticity, Kirchhoff’s laws and experimental measurements, etc. A good agreement is found between numerical simulation and experimental results, which verifies the accuracy of the theoretical model. Stability analysis is provided to determine the characteristics of the presented harvester. More importantly, it is numerically and experimentally verified that the presented harvester has a much lower cut-in wind speed (about 1.0 m s −1 ) and has a better energy harvesting performance at a low wind speed range from 1.0 m s −1 to 2.9 m s −1 , when compared with traditional FAEHs.
Limit cycle oscillation for an airfoil in transonic air flow considering aerodynamic nonlinearity is studied. Transonic nonlinear aerodynamic forces are calculated by solving Euler equations or Navier–Stokes equations with respect to harmonic airfoil plunging/pitching motion, and then the aerodynamic describing functions and the superposition principle are used to build an equivalent linearized aerodynamic model in the frequency domain; hence, the transonic limit cycle oscillation solutions can be obtained by the frequency domain flutter analysis method. The procedures for building the aerodynamic describing function and obtaining the limit cycle oscillation solution are described in detail. Four examples are adopted to verify the accuracy of the present method. The Isogai wing model with NACA 64A010 airfoil is used as the first example to verify the accuracy of the transonic linear flutter solution of the present method. Another NACA 64A010 airfoil model with different structural parameters is then adopted to study its transonic limit cycle oscillation characteristics considering only aerodynamic nonlinearity, and the NACA 0012 airfoil model with both aerodynamic and structural nonlinearities is investigated for its transonic limit cycle oscillation properties. The NLR 7301 airfoil is studied for its limit cycle oscillation characteristics in inviscid and viscous transonic flows, respectively. The results obtained by the present method are in good agreement with those obtained by the existing research with the harmonic balance method and time-marching method. The limitations of the present method are also discussed.
1 October 2016 in Journal of Fluids and Structures