Extensive research efforts are underway globally to develop new steel microstructure concepts for high-strength sheet products, driven largely by the need for lightweight automotive structures in support of designs to enhance occupant safety and energy efficiency. One promising approach, involving the quenching and partitioning (Q&P) process, was introduced in the predecessor to this paper series, Austenite Formation and Decomposition, 2003.[1] Development of the Q&P process has continued through to the present, and the current status is highlighted in this article, along with some alternative approaches that are also receiving attention. Special emphasis is placed on the synthesis and interpretation of the fundamental phase transformation responses, perspectives related to alloying and processing, and the resulting microstructure and properties. Key mechanistic issues are discussed, including carbide formation and suppression, migration of the martensite/austenite interface, carbon partitioning, and partitioning kinetics.
The role of retained austenite on tensile behavior in quenched and partitioned (Q&P) steels has been studied extensively, but the deformation behavior of martensite, which comprises the majority of Q&P microstructures, has received less attention. In this investigation, martensite properties were varied through heat treatment in a low carbon Q&P steel consisting of retained austenite and martensite. Additional conditions were produced by reheating the Q&P steel to 450 °C for 30 min or to 700 °C followed immediately by quenching. The reheated microstructures contained similar fractions of retained austenite as the non-reheated Q&P microstructures, but reheating tempered the martensite, thereby decreasing martensite dislocation density. The reheated conditions had a lower yield stress and initial work hardening rate than the non-reheated Q&P condition. However, the reheated conditions had a greater work hardening rate at larger strains and greater uniform strain due to less stable retained austenite. Furthermore, the tensile strength of the condition reheated to 450 °C was nearly equal to the non-reheated condition. In addition to retained austenite to martensite transformation, the early stage work hardening rate of martensite is critical to ductility and is dependent on martensite dislocation density, which can be decreased through tempering.
1 November 2015 in Materials Science and Technology
Hydrogen induced cracking (HIC) remains a prominent issue for oil and gas exploration in challenging environments. This assessment discusses HIC in light of hydrogen transport through pipeline steel microstructures and crack initiation and propagation processes. While there has been significant research in hydrogen permeation through steel alloys, additional understanding is necessary in microstructures specific to pipeline steels. Furthermore, a standard model for crack initiation and propagation processes needs to be established; a fracture mechanics based model, which has been used by some researchers, is presented in the present paper to predict crack propagation. Advanced characterisation techniques can help elucidate mechanisms of hydrogen induced crack growth. Ultimately, linking hydrogen transport and cracking processes during HIC will enable optimised alloy and microstructure design.
23 September 2011 in Metallurgical and Materials Transactions A