Superconducting electrodynamic suspension (EDS) is one of the potential schemes for high-speed rail transit. However, the electrodynamic dynamics modeling and the characterization of the irregularity of discretely-distributed null-flux coils are great challenges. In this study, a partition-computing mechatronics dynamics model that can reflect the high-frequency vibration and self-excited vibration is established. The design of frame spacing, irregularity and load spectrum are studied by our model, which cannot be calculated by the linear models before. Firstly, it is recommended that the frame spacing be greater than 12.6 m to ensure the same levitation performance of the frame. Secondly, the equivalent geometric irregularity model is established according to the geometric position of discretely-distributed coils. The main source of vibration is the mid-long-wave for geometric irregularity. According to the measured coils, the electrical parameters obey the normal distribution. The inductance irregularity, as the greatest impact of circuit irregularity, will cause relatively severe vibration. The standard deviation of the inductance of the engineering coil is recommended to be below 4.68×10 -6 H. Additionally, the load spectrum increases by 24%-76% compared with the design value.
10 September 2025 in IEEE Transactions on Energy Conversion
The electrodynamic suspension (EDS) system with cross-connected null-flux coil (NFC) configurations shows great potential for high-speed Maglev trains and electromagnetic launch systems. However, existing test platforms cannot experimentally simulate cross-connected NFC tracks. In this article, we propose a novel experimental approach to investigate the influence of cross-connection cables on dynamic performance in a laboratory environment. Firstly, a new rotating double-disk experimental EDS device equipped with cross-connected NFCs is introduced, with its structure, functions, and experimental procedures described in detail. Secondly, an efficient numerical model of the NFC-type EDS system, capable of accommodating general magnet arrays and arbitrary magnetization angles, is developed to support the electrical parameter design of the NFCs. Thirdly, comparisons of transient electromagnetic forces between numerical simulations (for both linear and rotary motion) and rotational experimental measurements demonstrate a high degree of consistency, validating the effectiveness of the proposed test platform. Finally, the transient performance of the EDS system with and without cross-connection cables is experimentally evaluated and compared. The results indicate that the cross-connected NFC configuration enhances the guidance force by 250% without compromising suspension performance. This experimental method, presented here for the first time, enables laboratory simulation of the dynamic behavior of cross-connected EDS systems and demonstrates considerable scalability. Moreover, the platform significantly enhances the capabilities of EDS testing by allowing flexible simulation of various coil and magnet configurations. As such, it provides an important reference framework for the design and experimental investigation of advanced EDS systems.
High-temperature superconducting (HTS) pinning magnetic levitation (maglev) systems are highly promising for future applications in rail transportation. Through the interaction between onboard HTS bulks and the permanent magnet guideway (PMG), this system generates levitation and guidance forces, known as the HTS-PMG relationship. Under practical conditions, this interaction manifests itself as a distributed force. However, past models have only considered concentrated forces. This study aims to design experiments to investigate the HTS-PMG relationship and propose a more realistic discretized lateral-vertical coupling HTS-PMG relationship to accurately reflect torques in dynamic simulations. Based on this, a dynamic model is established to analyze the Sperling index and the five-degree-of-freedom dynamic response of the HTS pinning maglev vehicle system under different HTS-PMG relationship models. The results indicate that the proposed discretized lateral-vertical coupling HTS-PMG relationship accurately characterizes the torque generated by the HTS levitator, influencing lateral, roll, pitch, and yaw motions to some extent. Compared with the concentrated force model, the discrete force model exhibits superior dynamic performance, particularly in terms of lateral dynamics and the lateral Sperling index. This study provides valuable insights into the field of HTS maglev, particularly regarding investigating HTS-PMG relationships and their impact on HTS maglev system dynamic performance.