7 June 2013 in Solar Physics
13 April 2016 in Journal of Physics D: Applied Physics
Thin films of tantalum nitride (Ta–N) have been prepared by reactive magnetron deposition under various nitrogen partial pressures and subsequently annealed ( T
a
= 450–950 °C). The structure, density, composition and electrical resistivity of the prepared films were systematically investigated. A phase map was constructed from the results of structural analysis. With increasing of from 0 to 0.2, a single-phase or two-phase mixture films of tetragonal Ta, Ta 2 N ( °C), ϵ-TaN ( °C), θ -TaN ( °C) and fcc δ -TaN are sequentially observed. For –0.45, the as grown and annealed films exhibit δ -TaN structure. Amorphous films grown in the –0.75 range crystallize as cubic Ta 2 N 3 upon annealing at °C or as δ -TaN at °C. A cubic Ta 2 N 3 is grown at highest ( 0.85), which decomposes to δ -TaN at °C. The N / Ta atomic ratio in the film linearly increases for –0.5, ranging from 0 to 2.1, while the mass density monotonically decreases with . Upon annealing, a part of N atoms out-diffuses from the films deposited at . The electrical resistivity strongly depends on both and T
a
. However, in the as grown and annealed δ -TaN films the resistivity was of the order of 100–1000 cm. In these films, a correlation between the resistivity and the average number of defects (Ta vacancies and N atom excess) is observed. Finally, the influence of thermally introduced oxygen on the films resistivity has been revealed.
30 January 2009 in Thin Solid Films
1 October 2016 in Journal of Alloys and Compounds
1 June 2012 in Physica B: Condensed Matter