9 February 2021 in IEEE Transactions on Wireless Communications
Variational message passing (VMP), belief propagation (BP) and expectation propagation (EP) have found their wide applications in complex statistical signal processing problems. In addition to viewing them as a class of algorithms operating on graphical models, this article unifies them under an optimization framework, namely, Bethe free energy minimization with differently and appropriately imposed constraints. This new perspective in terms of constraint manipulation can offer additional insights on the connection between different message passing algorithms and is valid for a generic statistical model. It also founds a theoretical framework to systematically derive message passing variants. Taking the sparse signal recovery (SSR) problem as an example, a low-complexity EP variant can be obtained by simple constraint reformulation, delivering better estimation performance with lower complexity than the standard EP algorithm. Furthermore, we can resort to the framework for the systematic derivation of hybrid message passing for complex inference tasks. Notably, a hybrid message passing algorithm is exemplarily derived for joint SSR and statistical model learning with near-optimal inference performance and scalable complexity.
13 March 2017 in IEEE Transactions on Wireless Communications
This paper studies the link level performance of orthogonal frequency division multiplexing (OFDM) and four other advanced waveforms, namely, filtered OFDM (F-OFDM), universal-filtered OFDM (UF-OFDM), filter bank multicarrier (FBMC) and generalized frequency division multiplexing (GFDM). Compared to OFDM, the two filtered variants achieve lower out-of-band (OOB) emissions and can mostly preserve the conventional OFDM-based transceiver design. For the latter two non-orthogonal waveforms, this paper proposes a low complexity implementation of minimum mean square error equalization to jointly tackle the channel and waveform-induced interference. On this basis, the benefits of FBMC and GFDM can be exploited with complexity comparable to the former (quasi-) orthogonal waveforms. The observed benefits include lower peak-to-average power ratio (PAPR) and smaller frame error rate (FER) under challenging doubly dispersive multiple-input multiple-output (MIMO) fading channels. Additionally, linear filtering of FBMC offers an ultra-low OOB emission, while a good compromise in the usage of time and frequency resources can be achieved by circular filtering of GFDM. In the comparison of offset quadrature amplitude modulation (OQAM) versus QAM for non-orthogonal waveforms, OQAM can offer lower PAPR, while smaller FERs can be achieved by QAM in rich multipath fading channels.
11 December 2017 in IEEE Transactions on Communications
Driven by 5G requirements, research on alternatives to the popular cyclic-prefix orthogonal frequency division multiplexing (CP-OFDM) waveform recently arose. In particular, non-orthogonal circularly filtered waveforms such as generalized frequency division multiplexing (GFDM) were proposed due to flexibility and robustness. Applying multiple-input multiple-output (MIMO) techniques for future wireless networks is unquestionable and thereby compulsory for any alternative waveform. Despite advancements in accurate MIMO detection algorithms for GFDM, compared to CP-OFDM their complexity still exhibited a higher order of magnitude, impeding an energy-efficient implementation. In this paper, we propose a low-complexity formulation for iterative minimum mean squared error with parallel interference cancellation (MMSE-PIC) detection for non-orthogonal waveforms with localized intercarrier interference (ICI), where we focus on the application to MIMO-GFDM. The proposal achieves complexity similar to CP-OFDM and we analyze its performance under realistic channel conditions with imperfect channel state information, where we obtain up to 2dB gain of GFDM compared to OFDM. We confirm our findings by analyzing the measured extrinsic information transfer (EXIT) charts and show that the proposal achieves the performance of optimal maximum likelihood (ML) detection. The results point out the MMSE-PIC algorithm as a viable technique for iterative MIMO receiver implementations for non-orthogonal waveforms.
17 September 2018 in IEEE Communications Letters
A highly relevant case of wireless transmission over time and/or frequency selective channels is when the channel state information is only known at the receiver. Under these scenarios, this paper aims to derive the necessary conditions for an unitary transmitter matrix to maximize the coded modulation (CM) capacity. We approach the problem by considering the CM capacity upper bound (UB) instead of the general one due to simplification of the problem and tightness at high signal-tonoise ratio (SNR) regions. The theoretical analysis reveals that the optimal waveforms spread the symbols over the domain of selectivity the channel. To demonstrate this result, we evaluate OFDM, single-carrier (SC) and the Orthogonal Chirp Division Multiplexing (OCDM) where we have that i) OCDM and SC are optimal for frequency-selective channels and ii) OCDM and OFDM are optimal for time-selective channels. Finally, we show that the UB has the same performance order as the real CM capacity, providing evidence that the UB criteria is meaningful for the optimization of a communication system.
5 July 2017 in IEEE Transactions on Vehicular Technology
Vehicular communications enable information exchange among vehicles including the roadside infrastructure. This has led to applications to primarily increase road safety and traffic efficiency. Standardization efforts on vehicular communications are underway. The physical layer (PHY) is defined based on the IEEE 802.11 family of WiFi standards operating at the 5.9 GHz frequency band and on extensions of long-term evolution (LTE); in both cases orthogonal frequency division multiplexing (OFDM) is the waveform of choice. Since the typical environment of WiFi deployment is very different to the vehicular communication environment, it is a challenging task to adapt the WiFi-based PHY for providing reliable and real-time communications under highly time- and frequency-selective fading channels. In this paper, the employment of an alternative waveform termed generalized frequency division multiplexing (GFDM) for vehicular communication is investigated. Specifically, a GFDM-based packet design is proposed on the basis of the standard-compliant OFDM-based PHY configuration. On the receiver side, this paper focuses on developing synchronization, channel estimation, and equalization algorithms. The performance of the resulting GFDM-based PHY is verified and compared with the OFDM-based one by means of simulation. The obtained results demonstrate that the proposed GFDM-based PHY can utilize the time and frequency resources more efficiently, and outperform particularly under challenging channel conditions. Additionally, the low out-of-band emission of GFDM is a desirable feature for future multichannel operation (MCO) in vehicular communications.
15 May 2017 in IEEE Transactions on Communications
As real-time applications typically require short length code words, this paper analyzes the minimum achievable code word error rate of the given finite-length code words, namely, maximum likelihood (ML) decoding error probability. For coding schemes ML decoding is too complex, the key contribution of this paper is to analytically assess the performance gap between ML decoding and a practical decoding scheme. We analyze the combination of turbo codes and bit-interleaved coded-modulation that is a spectrally efficient coding scheme adopted in 3GPP long term evolution (LTE). In single-input single-output (SISO) systems, it was shown in the literature that turbo decoding delivers near-ML decoding performance. In this paper, we extend the analysis to a multi-input multi-output (MIMO) system. In contrast to the SISO case, the turbo principle-based iterative decoding scheme is subject to appreciable performance loss compared with the ML decoding, even in good MIMO channel conditions. For this reason, we further analyze potential reasons and examine possible improvements. By means of simulation, it is shown that convergence to a non-ML code word rather than non-convergence is the key reason for the observed performance loss in good channel conditions.