12 August 2014 in Structural Concrete
7 August 2020 in Structural Concrete
Nowadays virtually all‐concrete construction uses reinforcement with deformations rolled or indented on the bar surface to improve bond between bar and concrete, but many older structures built with plain surface bars remain in service. The increasing need for assessment of existing construction means there is a continuing need for information on their performance. Research into plain surface bars essentially ceased when ribbed bars became established, and plain bars have consequently been bypassed in developments in understanding and modeling of bond since 1960. The profession's ability to numerically model behavior of concrete structures has expanded dramatically since plain surface reinforcement was discontinued. The option of numerically modeling may be particularly important for assessment of existing structures with noncompliant details. Although the fib Model Code 2010 includes a local bond–slip model for plain surface bars, information on the derivation of the model and supporting evidence of its validation are not available. The current paper analyses data on bond–slip behavior of plain surface bars and demonstrates shortcomings in the fib model. An improved model is proposed and verified against test data from an independent source.
15 August 2013 in Structural Concrete
10 April 2021 in Structural Concrete
The use of bundled bars in highly loaded concrete members instead of individual bars can reduce or even avoid reinforcement congestion, allowing easier placing and compaction of concrete, since bundles (with two or more side‐by‐side bars) are less obstructive to fresh‐concrete flow. However, there is still a lack in knowledge of the fundamental phenomena related to the bond behavior of bars in bundles. Therefore, design code rules for anchorages and splices differ significantly among International Standards (Eurocode 2, fib Model Code 2010, and ACI 318–19). The present paper reports the results of more than 100 pullout tests with short embedded length with the aim of comparing the local bond behavior of bundles with that of corresponding notional individual bars. Among the three criteria usually introduced to compare bundled and individual bars, based on the concepts of “equivalent sectional area,” and “minimum or maximum sectional perimeter,” the first and the second are introduced in this paper. Experimental results show that both criteria are suitable methods for evaluating the bearing capacity of bundled bar anchorages, even if equivalent area criterion seems to be slightly more conservative. The experimental results provide also information on the bursting forces generated by the wedge action of the ribs which clearly increases with bar diameter. Finally, experimental results are compared with design rules for anchorage strength of bundled bars as prescribed by fib‐Model Code 2010.
4 May 2023 in Structural Concrete
A beam‐end test is proposed in this paper and in the new fib Model Code 2020 to determine the effects of concrete type, confinement effects, and casting position on the anchorage strength of reinforcing bars. Two bars are cast in each specimen (in the two opposite corners), one in a “good” casting position and the other in “poor” casting position. The proposed test aims to be an economical bond test capable to represent actual conditions of anchored bars in real design practice. The test is also intended to verify whether existing provisions for bond and anchorage in the fib Model Code are suitable in nonconventional concrete. The validity of the proposed beam end type bond test is assessed by the results of more 60 tests on rebars having anchorage length of about 20 times the bar diameter in plain concrete, in fiber reinforced concrete, and in recycled aggregate concrete. Experimental results provide information both on the “top cast effect” in three types of concrete and on the effectiveness of fib Model Code provisions for anchorage when nonconventional concrete is used.
2 April 2018 in Structural Concrete