Clinical Relevance: High-concentration carbamide peroxide containing home bleaching may cause a varying influence on the microhardness of esthetic restorative materials.
The purpose of this study was to investigate surface roughness (Ra) and morphology of supra-nanofilled [Estelite Omega (EO), Estelite ∑ Quick (EQ)], micro-hybrid [Esthet.X HD (EHD), G-aenial (GAE)] and nano-hybrid [Clearfil Majesty Posterior (CMP), Charisma Diamond (CD), Beautifil II (BII)] composites polished with two-step polishing systems [Enhance/PoGo (EP); Venus Supra (VS)]. Composite discs, 30 of each type, were prepared. Each composite group was divided into three subgroups: Mylar (control), EP and VS. Ra was evaluated with profilometer. In each composite group, the control had the lowest Ra. With both polishing systems, EO and EQ had significantly the lowest Ra, whereas CMP and BII had the highest. Except for GAE, CD and BII, the differences in Ra between EP and VS in each composite group were significant, showing smoother surfaces for EP. Supra-nanofilled composites created smoother surfaces than nano-hybrids, and their performance was similar or slightly better than that of micro-hybrids.
Objective: To investigate the effect of a prophylaxis paste on surface roughness of different composites, enamel, dentin and porcelain surfaces.Methods: Three different composites (FiltekZ250/Group1, Filtek Supreme XT/Group2, Premise/ Group3), enamel/Group4, dentin/Group5 and porcelain/Group6 samples were used in this study. All specimens were prepared flat by SiC discs and polished with a diamond polishing paste. The surface roughness measurements were determined with a profilometer after polishing (initial surface roughness). Prophylaxis paste was applied to the samples for 12 seconds, renewing every 6 seconds. After cleaning the samples, roughness values were measured again. Data were analyzed by Kruskal Wallis and Dunn’s multiple comparison test. Wilcoxon test was performed for the comparison of the initial and final surface roughness values (P<.05). The results were evaluated within the P<.05 confidence level.Results: The mean %SMHC was:C=77.27%, CL= 72.45%, SL=78.43%, G=66.65% and P=67.95%. Comparing the %SMHC promoted by 5 soft drinks, SL = C > CL > P = G (P<.05). There was not significant correlation between %SMHC and the other variables tested for the five drinks (P>>.05)Results: The initial and final surface roughness values (μm) were determined as follows: Group1: 0.039±0.009 and 0.157±0.018, Group2: 0.023±0.005 and 0.145±0.027, Group3: 0.028±0.008 and 0.109±0.012, Group4: 0.024±0.006 and 0.071±0.015, Group5: 0.030±0.007 and 0.143±0.029, Group6: 0.024±0.006 and 0.064±0.014. Significant difference was determined between the initial and final values for all groups.Conclusions: Composite and dentin surfaces were more affected by the application of prophylaxis paste than enamel and porcelain surfaces. The prophylaxis paste increased the surface roughness of all groups, but did not reach the bacterial retention roughness rate of 0.2μm. (Eur J Dent 2012;6:1-8)