This article presents an in-depth study of material measurement, at G-band (140–220 GHz), using a commercially available material characterization kit (MCK). The permittivity of homogeneous dielectric materials, obtained from MCK measurements, rises slightly with frequency, and this does not agree with the expected physical behavior. Based on electromagnetic simulations and measurements, it has been identified that this small error is due to the dispersion associated with the corrugated horn antennas of the MCK. To address this problem, a simple phase compensation scheme has been proposed and applied to the measurement results of five common kinds of dielectric materials. The processed results eliminate the rising slope error observed in the raw data and are in good agreement with permittivity values reported in the literature, which validates the proposed approach.
13 July 2022 in IEEE Microwave and Wireless Components Letters
This work presents a new topology of evanescent mode filter (EMF) that allows for its efficient additive manufacturing (AM). Chamfered ridges which avoid the appearance of undesired supports when printed vertically (i.e., along the propagation axis of the filter) are considered. This strategy ensures accurate tolerances, reduced cost and it also enables monolithic manufacturing of the EMF as part of a feed chain. A circuit model is developed to explain the behavior of the new ridges as well as to speed up the overall filter design. The proposed concept and methodology are validated experimentally through the manufacturing and measurement of a prototype.