Martin W. Rupich

Martin W. Rupich

Auto-generated profile, based on publicly available information

Martin W. Rupich

American Superconductor Corporation, Ayer, MA, USA

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
9 March 2023 in Superconductor Science and Technology
Verified
Journal Article
Open access
PDF file
NSNicholas M Strickland
Nicholas M Strickland
Stuart WimbushStuart Wimbush
Stuart Wimbush
ASArya Ambadiyil Soman
Arya Ambadiyil Soman
NLNicholas Long
Nicholas Long
MRMartin W Rupich
Martin W Rupich
PKPatrick Kluth
Patrick Kluth
Normal-incidence irradiation by 100 MeV Ag ions is used to improve flux pinning in previously optimised commercial REBCO tapes from the American Superconductor Corporation. We observe distinct critical-current anisotropy enhancements below and above 40 K. Above 40 K a strong c-axis peak appears in the angular dependence of the critical current, as is usually expected upon the introduction of columnar defects. The critical current is enhanced significantly but only for a limited range of field angles. Close to the parallel-field direction there is no enhancement or even a reduction in critical current. Below 40 K, on the other hand, the enhancement is much broader with respect to field angle, creating an almost isotropic response at 20 K, 3 T. The absence of a prominent c-axis peak does not indicate a lack of pinning, since the absolute value of the critical current still increases by a factor of 2.8 compared to an unirradiated sample. Instead, we postulate that pre-existing point-like pinning centres act to mediate an interaction between the existing planar and newly-introduced columnar pins, broadening both contributions. The point-like pins become less effective with increasing temperature as the coherence length increases, leading to a reduction in this interaction and a separation of the individual peaks relating to planar and columnar pins. At 20 K, we achieve an enhancement in the angular-minimum critical current by a factor of 2.7, in a material that had already been process-optimised for low-temperature pinning.

13 January 2022 in IEEE Transactions on Applied Superconductivity
Verified
Journal Article
Closed access
NSNicholas M. Strickland
Nicholas M. Strickland
Stuart WimbushStuart Wimbush
Stuart Wimbush
ASArya A. Soman
Arya A. Soman
PKPatrick Kluth
Patrick Kluth
CNChristian Notthoff
Christian Notthoff
MRMartin W. Rupich
Martin W. Rupich
Ion irradiation of REBCO films and coated conductors, in which the ions pass completely through the REBCO film, produces damage tracks which form near-ideal flux-pinning defects. The radius and aspect ratio of the tracks depends on the mass and energy of the incident ions. We have investigated the effect of Ag ion irradiation, at different incident energies and incidence angles, on REBCO production-quality coated conductors from American Superconductor Corp. Transmission electron microscopy and in-field transport critical current anisotropy analysis indicates that the ion-energy threshold for the formation of elongated tracks is around 50 MeV. At this energy tracks are not readily identifiable in low-resolution TEM, and enhancement of critical current is nearly isotropic. For a higher ion energy of 100 MeV, on the other hand, clear elongated (but still not fully continuous) tracks are visible in TEM, and the critical current is anisotropic with strong enhancement occurring when the applied field is parallel to the ion incidence angle. We particularly analyze the case of 60° inclined irradiation. This produces a clear peak in the field-angle dependence of critical current for 100 MeV irradiation, but only an incipient peak for 50 MeV irradiation. The incipient peak can be identified by curve fitting using a minimal number of maximum-entropy functional components.

21 January 2019 in IEEE Transactions on Applied Superconductivity
Verified
Journal Article
Closed access
NSNicholas M. Strickland
Nicholas M. Strickland
Stuart WimbushStuart Wimbush
Stuart Wimbush
MRMartin W. Rupich
Martin W. Rupich
NLNicholas Long
Nicholas Long
A sharp dip in critical current has been observed in the field dependence of the critical current $I$ $_c$ of commercial AMSC second-generation high-temperature superconducting tapes on Ni-5%W substrates, when the field is applied parallel to the plane of the tape. The dip occurs centered at a non-zero field for one field polarity only – the polarity in which the Lorentz force in the superconductor is towards the substrate. The polarity for which the dip occurs changes with sample orientation and current direction, remaining consistent with the direction of the Lorentz force relative to the substrate. Angle dependences of $I$ $_c$ in these tapes are consistent with this effect, lacking the usual 180° periodicity when measured under magnetic field strengths matching that of the dip in the field dependence. These effects are not observed on otherwise identical tapes produced on non-magnetic Ni-9%W substrates, indicating that the ferromagnetism of the substrate plays a determining role. A finite-element model shows that this asymmetrical dip occurs naturally as a result of field concentration in the magnetic substrate leading to a significant perpendicular component of field in the superconductor at a particular non-zero field strength.

1 July 2015 in Journal of Nuclear Materials
Verified
Journal Article
Closed access
AGA.A. Gapud
A.A. Gapud
NGN.T. Greenwood
N.T. Greenwood
JAJ.A. Alexander
J.A. Alexander
AKA. Khan
A. Khan
KLK.J. Leonard
K.J. Leonard
YZY. Zhang
Y. Zhang

25 October 2017 in IEEE Transactions on Applied Superconductivity
Verified
Journal Article
Closed access
JPJoseph C. Prestigiacomo
Joseph C. Prestigiacomo
RARaymond C. Y. Auyeung
Raymond C. Y. Auyeung
KCKristin Charipar
Kristin Charipar
JCJohn Claassen
John Claassen
NBNabil Bassim
Nabil Bassim
SPSastry Pamidi
Sastry Pamidi
A scalable laser lithographic process has been used to striate second-generation high-temperature superconducting coated conductors manufactured with a rolling-assisted biaxially textured substrate and metal organic deposition process by American Superconductor Corporation to reduce ac losses for electric power applications. The process involves laser patterning a resist coating and etching, which can be scaled up for commercial production. The results show that the critical current, $\boldsymbol{I}_{\boldsymbol{c}}$ , is not degraded for striation widths greater than 150 μm and that the ac losses for the 150-μm wide striations are reduced from the unpatterned 1-cm wide conductor by a factor of 15 for a 60-mT perpendicular peak magnetic field at 50 Hz.

27 January 2023 in IEEE Transactions on Applied Superconductivity
Verified
Journal Article
Closed access
NSN. M. Strickland
N. M. Strickland
ASA. A. Soman
A. A. Soman
NLNicholas Long
Nicholas Long
PKPatrick Kluth
Patrick Kluth
CNChristian Notthoff
Christian Notthoff
Stuart WimbushStuart Wimbush
Stuart Wimbush
Heavy-ion irradiation of solids produces damage tracks with radii typically of the order of 1 nm, depending on the ion species and energy. In cuprate superconductors this is close to the coherence length, which makes these defects highly effective flux pinning centers. Varying the ion-beam energy allows tuning of the dimensionality of the defects created, with higher-energy ions tending to produce columnar tracks and lower-energy ions tending to produce point-like defects. Starting with consistent production-standard REBCO tape from American Superconductor we have explored the energy-dependence of silver-ion irradiation and characterized the irradiated samples with angle-dependent transport critical current measurements. Using silver ions with energies in the range 50 MeV to 150 MeV and fluence of 4 × 10 11 ions/cm 2 we have been able to tune the irradiation-induced damage from point-like defects to columnar tracks, manifesting in changes to the pinning landscape ranging from isotropic critical current enhancement to the production of strong peaks in the angle dependence of critical current.