This paper proposes a local sliding mode control (SMC) strategy for frequency regulation and active power sharing in islanded microgrids (MGs). Unlike advanced strategies, either droop-based or droop-free, that rely on inter-inverter communication, the proposed method operates in a fully decentralized manner, using only measurements available at each inverter. In addition, it adopts a minimalist structure that avoids adaptive laws and consensus mechanisms, which simplifies implementation. A discontinuous control law is derived to enforce sliding dynamics on a frequency-based surface, ensuring robust behavior in the face of disturbances, such as clock drifts, sudden load variations, and topological reconfigurations. A formal Lyapunov-based analysis is conducted to establish the stability of the closed-loop system under the proposed control law. The method guarantees that steady-state frequency deviations remain bounded and predictable as a function of the controller parameters. Simulation results demonstrate that the proposed controller achieves rapid frequency convergence, equitable active power sharing, and sustained stability. Owing to its communication-free design, the proposed strategy is particularly well-suited for MGs operating in rural, isolated, or resource-constrained environments. A comparative evaluation against both conventional droop and communication-based droop-free SMC approaches further highlights the method’s strengths in terms of resilience, implementation simplicity, and practical deployability.
Fuel efficiency and CO₂ emissions of vehicles are influenced by various factors, including altitude, whose effect is often ignored or underestimated. This study evaluates the effect of altitude on fuel consumption and CO₂ emissions in a light vehicle through an experimental campaign in four cities in Ecuador located between sea level and 3,000 meters above sea level. Fuel consumption and engine operation data were obtained through the OBD system. This information was used to generate engine maps and analyse vehicle performance at different altitude levels.The results showed that in cities at higher altitudes, the vehicle operated with engine loads above 70% due to slopes greater than 7%, while in coastal cities the loads were lower. Under similar engine load conditions, both fuel consumption and CO₂ rates were lower in high-altitude cities, showing a positive effect of altitude on combustion. However, energy-based emission factors were higher in high-altitude cities, probably due to lower air density. In terms of distance, fuel consumption and CO₂ emission factors were up to 7% higher in high-altitude cities. Overall, this study proposes a low-cost methodology and shows the importance of considering the effect of altitude when designing sustainable transport strategies for Latin American cities.
La conducción urbana a nivel mundial se caracteriza por el frecuente tiempo en ralentí de los vehículos, debido a la congestión del tráfico. Esto impacta significativamente en el consumo de combustible y las emisiones de los vehículos. Si bien se han estudiado ampliamente estrategias como las técnicas de conducción ecológica y los sistemas start-stop en varias regiones, se ha realizado poca investigación para evaluar sus efectos en América Latina. Este estudio evalúa el impacto del ralentí, el tráfico y la conducción ecológica en el consumo de combustible y las emisiones de CO₂ de pozo a rueda (WTW) en las operaciones de taxis urbanos bajo condiciones de tráfico real en Ecuador. Se recopilaron datos de conducción real utilizando diagnóstico a bordo (OBD). Una innovación clave de esta investigación es la evaluación de escenarios alternativos, con tiempos ralentí y demanda de potencia reducidos, basada en el enfoque de Potencia Específica del Vehículo (VSP). Como resultado, se examinaron cinco escenarios: línea base, conducción ecológica, bajo tráfico, tecnología start-stop, y un escenario combinado. Los resultados muestran que la conducción urbana resultó en las mayores emisiones de CO₂ WTW (354 gCO₂/km) en comparación con la conducción rural y en carretera. El escenario combinado, que fusiona una menor demanda de potencia con la tecnología start-stop, logró mayores mejoras, reduciendo las emisiones de CO₂ WTW y el consumo de combustible en un 15 % en comparación con el escenario base. Anualmente, el escenario combinado podría evitar 3.68 toneladas de CO₂ emitidas por vehículo y ahorrar 870 USD en combustible. Estos hallazgos subrayan el potencial de la conducción ecológica y la tecnología de arranque y parada para reducir el consumo de combustible y las emisiones, contribuyendo a mitigar el impacto ambiental del transporte por carretera.
Latin American cities have pollution and traffic problems due to the lack of research and planning in the transport sector. In Ecuador, the characteristics of the transport fleets and their kinematics in the city have not been determined. This study analyzes in detail the kinematic characteristics of each public transport route in the city of Ibarra-Ecuador using GPS georeferencing equipment for each second of travel. 22 urban bus routes were monitored evaluating 186 buses in 832 trips, where it was determined that the average speed, acceleration and deceleration depend mainly on three factors: route, city sector and vehicle model. Other factors such as operator, age of driver, travel times and time slot did not show greater significance in influencing the kinematic variables under study, so it is not considered within the research study.