Polymerized ionic liquids or poly(ionic liquids) (polyILs) have been considered as promising hosts for fabrication of gel polymer electrolytes (GPEs) containing ionic liquids. In this work, a novel GPE based on a polyIL, poly(diallyldimethylammonium) bis(trifluoromethanesulfonyl)imide (PDADMA TFSI), and a high lithium-concentration phosphonium ionic liquid, trimethyl(isobutyl)phosphonium bis(fluorosulfonyl)imide (P111i4FSI), is prepared. The composition-dependent behaviour of the GPEs is investigated by differential scanning calorimetry (DSC), electrochemical impedance spectroscopy (EIS) and solid-state nuclear magnetic resonance (solid-state NMR). The effects of Al2O3 nano-particles on the polymer electrolyte properties are also discussed. It is shown that the introduction of high lithium-concentration ionic liquids into the polyIL can effectively decrease the glass transition temperature (Tg) of the resulting GPE, leading to improved ion dynamics and higher ionic conductivity. The Al2O3 nano-particles effectively enhanced the mechanical stability of the GPEs. Most importantly, although adding PDADMA TFSI to the ionic liquids decreases the diffusion coefficient of both Li+ and anions, a greater decrease in the anion diffusion is observed, resulting in a higher Li+ transport number (as evaluated by NMR) than that seen in the original ILs. Finally, a highly conductive free-standing GPE membrane is fabricated, and extremely stable lithium symmetrical cell performance is demonstrated.
Composite of anatase titania (TiO2) nanospheres and carbon grown and self-assembled into micron-sized mesoporous spheres via a solvothermal synthesis route are discussed here in the context of rechargeable lithium-ion battery. The morphology and carbon content and hence the electrochemical performance are observed to be significantly influenced by the synthesis parameters. Synthesis conditions resulting in a mesoporous arrangement of an optimized amount carbon and TiO2 exhibited the best lithium battery performance. The first discharge cycle capacity of carbon-titania mesoporous spheres (solvothermal reaction at 150 °C at 6 h, calcination at 500 °C under air, BET surface area 80 m2g−1 ) was 334 mAhg−1 (approximately 1 Li) at current rate of 0.066 Ag−1. High storage capacity and good cyclability is attributed to the nanostructuring of TiO2 (mesoporosity) as well as due to formation of a percolation network of carbon around the TiO2 nanoparticles. The micron-sized mesoporous spheres of carbon-titania composite nanoparticles also show good rate cyclability in the range (0.066–6.67) Ag−1.
A composite anode comprising of a 3D network of few-layer MoO 3 nanosheets with an optimum amount of rGO exhibits excellent Na-ion cyclability over wide ranging values of operating current densities. Ultrathin nanosheets of MoO 3 are synthesized by oxidation of MoS2 nanosheets and are tagged with optimum amounts of rGO.