As the foundation of marine infrastructure, pile groups are subjected to extreme wave loads. Existing research primarily focuses on regular waves and wave forces. There is limited research on the pressure distribution of pile bodies under extreme waves. This paper describes a wave flume experiment where waves of a self-proposed extreme wave type were generated. The experiment considers three water depths (25/35/45 cm), three wave-pushing velocities (20/30/40 cm/s), and two clear distances (D, 2D). A total of 216 measuring points equipped with digital pressure sensors captured the vertical and circumferential pressure distribution and wave positive force. The results show that (1) the vertical and circumferential pressure distribution patterns of each component pile and the single pile are similar in various loading scenarios and clear distances. (2) The measuring point pressure, pressure after circumferential integration, and wave positive force are positively correlated with wave-pushing velocity. (3) The wave pressure is positively correlated with the water depth, while the pressure after circumferential integration is negatively correlated with the water depth. (4) When the clear distance is D, the wave positive force coefficient of each component pile is less than 1.0.
Wave-induced forces pose significant challenges to marine structures, especially pile groups, where cap structures and pile spacings play critical roles in load distribution and structural stability. A physical wave flume experiment was conducted to investigate the influences of cap structures and pile spacings on wave load distributions under different wave conditions. Spatial and temporal variations in wave load distributions, including temporal variations in horizontal force, were measured as wave pressure rather than force. The results demonstrate that cap structures significantly alter the distributions of wave loads on pile groups. The integration of the cap increases the horizontal forces on the front pile and slightly reduces the vertical pressures across the pile group, particularly on the rear pile at relatively low elevations. The cap also delays the peak moment of horizontal force, especially in shallow water depths, where impact loads are more prominent and the cap induces water splash-back. Additionally, reducing pile spacing mitigates interference effects, optimizing the load distribution across piles by modulating flow velocity and pressure. The vertical pressure distribution exhibits a tiered pattern, with lower sections experiencing consistent loading, middle sections being subjected to higher loads at larger spacings, and upper sections being more affected by the cap at smaller spacings. As wave velocity and water depth increase, the differences in pressure intensity between pile groups with and without cap structures decrease, indicating the stabilizing effect of wave characteristics on structural response. This study provides insights into the design of marine pile group structures to optimize their performance characteristics under dynamic wave loading conditions.