Acceleration measurement is widely used in commercial, scientific, and defense applications, but the resolution and accuracy achievable for demanding applications is limited by the current technology used to build and calibrate accelerometers. We report an optomechanical accelerometer based on a Fabry–Perot microcavity in a silicon chip that is extremely precise, field deployable, and can self-calibrate. The measured acceleration resolution is the highest reported to date for a microfabricated optomechanical accelerometer and is achieved over a wide frequency range ( over 6.8 kHz). The combination of a single vibrational mode in the mechanical spectrum and the broadband thermally limited resolution enables accurate conversion from sensor displacement to acceleration. This also allows measurement of acceleration directly in terms of the laser wavelength, making it possible for sensors to calibrate internally and serve as intrinsic standards. This sensing platform is applicable to a range of measurements from industrial accelerometry and inertial navigation to gravimetry and fundamental physics.
19 February 2016 in IEEE Photonics Technology Letters
The tunability of an optical cavity is an essential requirement for many areas of research. Here, we use the Pound–Drever–Hall technique to lock a laser to a whispering gallery mode (WGM) of a microbubble resonator, to show that linear tuning of the WGM, and the corresponding locked laser, display almost zero hysteresis. By applying aerostatic pressure to the interior surface of the microbubble resonator, optical mode shift rates of around 58 GHz/MPa are achieved. The microbubble can measure pressure with a detection limit of $2\times 10^{-4}$ MPa, which is an improvement made on pressure sensing using this device. The long-term frequency stability of this tuning method for different input pressures is measured. The frequency noise of the WGM measured over 10 min for an input pressure of 0.5 MPa has a maximum standard deviation of 36 MHz.
We report on tuning the optical whispering gallery modes (WGMs) in a poly dimethyl siloxane-based (PDMS) microsphere resonator by more than 1 THz. The PDMS microsphere system consists of a solid spherical resonator directly formed with double stems on either side. The stems act like tie-rods for simple mechanical stretching of the microresonator, resulting in tuning of the WGMs by one free spectral range. Further investigations demonstrate that the WGM shift has a higher sensitivity () to an applied force when the resonator is in its maximally stretched state compared to its relaxed state.
Dissipative optomechanics has some advantages in cooling compared to the conventional dispersion dominated systems. Here, we study the optical response of a cantilever-like, silica, microsphere pendulum, evanescently coupled to a fiber taper. In a whispering gallery mode resonator, the cavity mode and motion of the pendulum result in both dispersive and dissipative optomechanical interactions. This unique mechanism leads to an experimentally observable, asymmetric response function of the transduction spectrum, which can be explained using coupled-mode theory. The optomechanical transduction and its relationship to the external coupling gap are investigated, and we show that the experimental behavior is in good agreement with the theoretical predictions. A deep understanding of this mechanism is necessary to explore trapping and cooling in dissipative optomechanical systems.
Microbubbles are thin spherical shells that can support whispering gallery modes, with evanescent fields inside and outside the resonator. We report on using microbubble resonators for temperature sensing via the large temperature dependent refractive index of fluid contained in the microbubble and for optomechanics.
2 THz tuning of optical WGMs is observed in a stretchable PDMS microresonator, demonstrating sensitivities as high as 0.13 nm/μN. The structure also provides the possibility of observing mechanical modes with frequencies in kHz range.