Feng Zhou

Feng Zhou

Auto-generated profile, based on publicly available information

Feng Zhou

National Institute of Standards and Technology 1 , Gaithersburg, Maryland 20899, USA

Research Focus & Metrics

Academic Career Length

36Years (1991-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
9 March 2021 in Optica
Verified
Journal Article
Closed access
FZFeng Zhou
Feng Zhou
YBYiliang Bao
Yiliang Bao
RMRamgopal Madugani
Ramgopal Madugani
DLDavid A. Long
David A. Long
JGJason J. Gorman
Jason J. Gorman
TLThomas W. LeBrun
Thomas W. LeBrun
Acceleration measurement is widely used in commercial, scientific, and defense applications, but the resolution and accuracy achievable for demanding applications is limited by the current technology used to build and calibrate accelerometers. We report an optomechanical accelerometer based on a Fabry–Perot microcavity in a silicon chip that is extremely precise, field deployable, and can self-calibrate. The measured acceleration resolution is the highest reported to date for a microfabricated optomechanical accelerometer and is achieved over a wide frequency range ( 314 n m ⋅ s − 2 / √ H z over 6.8 kHz). The combination of a single vibrational mode in the mechanical spectrum and the broadband thermally limited resolution enables accurate conversion from sensor displacement to acceleration. This also allows measurement of acceleration directly in terms of the laser wavelength, making it possible for sensors to calibrate internally and serve as intrinsic standards. This sensing platform is applicable to a range of measurements from industrial accelerometry and inertial navigation to gravimetry and fundamental physics.

16 January 2023 in Nature Communications
Verified
Journal Article
Open access
PDF file
EPEdgar F. Perez
Edgar F. Perez
GMGrégory Moille
Grégory Moille
XLXiyuan Lu
Xiyuan Lu
JSJordan Stone
Jordan Stone
FZFeng Zhou
Feng Zhou
KSKartik Srinivasan
Kartik Srinivasan
Optical parametric oscillation (OPO) is distinguished by its wavelength access, that is, the ability to flexibly generate coherent light at wavelengths that are dramatically different from the pump laser, and in principle bounded solely by energy conservation between the input pump field and the output signal/idler fields. As society adopts advanced tools in quantum information science, metrology, and sensing, microchip OPO may provide an important path for accessing relevant wavelengths. However, a practical source of coherent light should additionally have high conversion efficiency and high output power. Here, we demonstrate a silicon photonics OPO device with unprecedented performance. Our OPO device, based on the third-order (χ(3)) nonlinearity in a silicon nitride microresonator, produces output signal and idler fields widely separated from each other in frequency ( > 150 THz), and exhibits a pump-to-idler conversion efficiency up to 29 % with a corresponding output idler power of > 18 mW on-chip. This performance is achieved by suppressing competitive processes and by strongly overcoupling the output light. This methodology can be readily applied to existing silicon photonics platforms with heterogeneously-integrated pump lasers, enabling flexible coherent light generation across a broad range of wavelengths with high output power and efficiency.

29 January 2021 in Optics Letters
Verified
Journal Article
Closed access
PDF file
DLD. A. Long
D. A. Long
BRB. J. Reschovsky
B. J. Reschovsky
FZF. Zhou
F. Zhou
YBY. Bao
Y. Bao
TLT. W. LeBrun
T. W. LeBrun
JGJ. J. Gorman
J. J. Gorman
Electro-optic frequency combs were employed to rapidly interrogate an optomechanical sensor, demonstrating spectral resolution substantially exceeding that possible with a mode-locked frequency comb. Frequency combs were generated using an integrated-circuit-based direct digital synthesizer and utilized in a self-heterodyne configuration. Unlike approaches based upon laser locking, the present approach allows rapid, parallel measurements of full optical cavity modes, large dynamic range of sensor displacement, and acquisition across a wide frequency range between DC and 500 kHz. In addition to being well suited to measurements of acceleration, this optical frequency comb-based approach can be utilized for interrogation in a wide range of cavity optomechanical sensors.

28 June 2022 in Optics Letters
Verified
Journal Article
Closed access
PDF file
XLXiyuan Lu
Xiyuan Lu
ACAshish Chanana
Ashish Chanana
FZFeng Zhou
Feng Zhou
MDMarcelo Davanco
Marcelo Davanco
KSKartik Srinivasan
Kartik Srinivasan
Continuous wave optical parametric oscillation (OPO) provides a flexible approach for accessing mid-infrared wavelengths between 2 µm and 5 µm, but operation at these wavelengths has not yet been integrated into silicon nanophotonics. Typically, a Kerr OPO uses a single transverse mode family for pump, signal, and idler modes, and relies on a delicate balance to achieve normal (but close-to-zero) dispersion near the pump and the requisite higher-order dispersion needed for phase- and frequency-matching. Within integrated photonics platforms, this approach results in two major problems. First, the dispersion is very sensitive to geometry, so that small fabrication errors can have a large impact. Second, the device is susceptible to competing nonlinear processes near the pump. In this Letter, we propose a flexible solution to infrared OPO that addresses these two problems by using a silicon nitride photonic crystal microring (PhCR). The frequency shifts created by the PhCR bandgap enable OPO that would otherwise be forbidden. We report an intrinsic optical quality factor up to (1.2 ± 0.1)×106 in the 2-µm band, and use a PhC ring to demonstrated an OPO with a threshold dropped power in the cavity of (90 ± 20) mW, with the pump wavelength at 1998 nm, and the signal and idler wavelengths at 1937 nm and 2063 nm, respectively. We further discuss how to extend the OPO spectral coverage in the mid-infrared. These results establish the PhCR OPO as a promising route for integrated laser sources in the infrared.

28 April 2022 in Optics Express
Verified
Journal Article
Closed access
BRBenjamin J. Reschovsky
Benjamin J. Reschovsky
DLDavid A. Long
David A. Long
FZFeng Zhou
Feng Zhou
YBYiliang Bao
Yiliang Bao
RARichard A. Allen
Richard A. Allen
JGJason J. Gorman
Jason J. Gorman
We demonstrate a microfabricated optomechanical accelerometer that is capable of percent-level accuracy without external calibration. To achieve this capability, we use a mechanical model of the device behavior that can be characterized by the thermal noise response along with an optical frequency comb readout method that enables high sensitivity, high bandwidth, high dynamic range, and SI-traceable displacement measurements. The resulting intrinsic accuracy was evaluated over a wide frequency range by comparing to a primary vibration calibration system and local gravity. The average agreement was found to be 2.1 % for the calibration system between 0.1 kHz and 15 kHz and better than 0.2 % for the static acceleration. This capability has the potential to replace costly external calibrations and improve the accuracy of inertial guidance systems and remotely deployed accelerometers. Due to the fundamental nature of the intrinsic accuracy approach, it could be extended to other optomechanical transducers, including force and pressure sensors.

28 October 2022 in Physical Review Letters
Verified
Journal Article
Closed access
PDF file
MWMingkang Wang
Mingkang Wang
FZFeng Zhou
Feng Zhou
XLXiyuan Lu
Xiyuan Lu
AMAndrew McClung
Andrew McClung
MDMarcelo Davanco
Marcelo Davanco
KSKartik Srinivasan
Kartik Srinivasan
Whispering gallery modes (WGMs) in circularly symmetric optical microresonators exhibit integer quantized angular momentum numbers due to the boundary condition imposed by the geometry. Here, we show that incorporating a photonic crystal pattern in an integrated microring can result in WGMs with fractional optical angular momentum. By choosing the photonic crystal periodicity to open a photonic band gap with a band-edge momentum lying between that of two WGMs of the unperturbed ring, we observe hybridized WGMs with half-integer quantized angular momentum numbers (m∈Z+1/2). Moreover, we show that these modes with fractional angular momenta exhibit high optical quality factors with good cavity-waveguide coupling and an order of magnitude reduced group velocity. Additionally, by introducing multiple artificial defects, multiple modes can be localized to small volumes within the ring, while the relative orientation of the delocalized band-edge states can be well controlled. Our Letter unveils the renormalization of WGMs by the photonic crystal, demonstrating novel fractional angular momentum states and nontrivial multimode orientation control arising from continuous rotational symmetry breaking. The findings are expected to be useful for sensing and metrology, nonlinear optics, and cavity quantum electrodynamics.