25 April 2023 in IEEE Transactions on Power Systems
A computationally efficient and accurate reduced-order model (ROM) that characterizes the time-scale coupling caused by the high penetration of power-electronic converters in microgrids (MGs) is crucial to system stability analysis. When such MGs are interconnected into multi-microgrids (MMGs), the coupling between fast and slow dynamics will be more complicated due to the interactions among each MG. The traditional ROM without concerning dynamic coupling may lead to low accuracy and even misjudgment of system stability. In this paper, by considering primary energy dynamics of renewable energy sources, e.g., doubly-fed induction generator (DFIG) and photovoltaic (PV), a small-signal model that characterizes the practical multi-timescale of MMGs is firstly presented. Then with the division of the entire MMGs into fast and slow dynamic subsystems based on the assumption of time-scale separating, the coupling dynamics are identified via the residues-based method. Finally, a ROM considering coupling dynamics and preserving physical meaning is proposed by reconfiguring the fast and slow dynamic subsystems based on singular perturbation. The accuracy of the proposed ROM is verified by comparing it with the detailed model under different control parameters, wind speeds and irradiance conditions. The time-domain simulation is employed to validate the dynamic response of the proposed ROM.
20 March 2023 in IEEE Transactions on Sustainable Energy
With the rapid promotion of photovoltaic (PV) power generation, the local consumption of distributed PV power generation at medium and low voltage levels widely forms PV-based microgrids. The continuous increase in the penetration rate of uncertain PV power generation requires it to actively participate in the frequency and voltage regulation of weak microgrid systems. Finite control set-model predictive control (FCS-MPC) for voltage source converter (VSC) shows remarkable advantages in fast dynamic response and robustness compared with traditional cascaded linear control methods. However, the traditional FCS-MPC method for VSC without considering the DC-link voltage dynamic of the PV generator will face oscillations of power and frequency in PV-based microgrids. In this paper, to suppress the low-frequency oscillation issue caused by PV generations, an improved FCS-MPC (I-FCS-MPC) strategy considering the DC-link dynamics of PV generation is proposed, in which the AC side and DC side of the VSC are comprehensively considered to enhance the dynamic performance of the PV-based microgrids. Moreover, a DC-link voltage regulation mechanism is introduced, enabling the PV generators to operate in the maximum power point tracking (MPPT) mode. Finally, experiments are conducted to verify the effectiveness of the proposed control strategy comprehensively.
31 December 2024 in IEEE Transactions on Smart Grid
The transition from traditional power systems to smart grids has led to the widespread utilization of multi-microgrids (MMGs) as a medium for integrating renewable energy sources (RES). However, due to the weak damping and low inertia characteristics of interconnected systems, multi-scale oscillation problems inevitably arise during autonomous operation. In order to explore these undesirable oscillation characteristics and achieve effective suppression. Firstly, this paper establishes a wind-solar hybrid MMGs model considering the characteristics of primary energy side and uncertain disturbances, and further reveals the correlation between system states and dominant oscillatory modes through eigenvalue analysis. Meanwhile, modal controllability and observability quantification analysis are employed to optimize the selection of measurement and control signals for the stabilization controller. Secondly, a hierarchical distributed model predictive stabilization control (HDMPSC) strategy with two-level oscillation control loops is innovatively proposed, where lower-level controllers are designed to address local modes and upper-level controllers work collaboratively to effectively mitigate poorly damped inter-area modes. Besides, the operational constraints are included in all stabilization controllers, providing a more feasible and reliable solution space. Finally, time-domain simulation and hardware-in-the-loop (HIL) experimental results verify the effectiveness of the proposed control scheme.