Background: Autologous bone grafts remain the gold standard for craniofacial reconstruction despite limitations of donor-site availability and morbidity. A myriad of commercial bone substitutes and allografts are available, yet no product has gained widespread use because of inferior clinical outcomes. The ideal bone substitute is both osteoconductive and osteoinductive. Craniofacial reconstruction often involves irregular three-dimensional defects, which may benefit from malleable or customizable substrates. “Hyperelastic Bone” is a three-dimensionally printed synthetic scaffold, composed of 90% by weight hydroxyapatite and 10% by weight poly(lactic-co-glycolic acid), with inherent bioactivity and porosity to allow for tissue integration. This study examines the capacity of Hyperelastic Bone for bone regeneration in a critical-size calvarial defect. Methods: Eight-millimeter calvarial defects in adult male Sprague-Dawley rats were treated with three-dimensionally printed Hyperelastic Bone, three-dimensionally printed Fluffy–poly(lactic-co-glycolic acid) without hydroxyapatite, autologous bone (positive control), or left untreated (negative control). Animals were euthanized at 8 or 12 weeks postoperatively and specimens were analyzed for new bone formation by cone beam computed tomography, micro–computed tomography, and histology. Results: The mineralized bone volume–to–total tissue volume fractions for the Hyperelastic Bone cohort at 8 and 12 weeks were 74.2 percent and 64.5 percent of positive control bone volume/total tissue, respectively (p = 0.04). Fluffy–poly(lactic-co-glycolic acid) demonstrated little bone formation, similar to the negative control. Histologic analysis of Hyperelastic Bone scaffolds revealed fibrous tissue at 8 weeks, and new bone formation surrounding the scaffold struts by 12 weeks. Conclusion: Findings from our study suggest that Hyperelastic Bone grafts are effective for bone regeneration, with significant potential for clinical translation.
Fat grafting has become a well-accepted surgical modality to correct soft tissue facial defects and asymmetries with overall good results. Several techniques have been reported over the last few years to assist in improving accurate evaluation of facial defects and in the preoperative planning of the reconstruction. Such techniques include among others, computer tomography, three-dimensional (3D) photogrammetry, high resolution ultrasound, and 3D laser scanning. There are advantages and disadvantages for each technique. With the rapid advance of 3D technologies that have become readily available to clinicians, new clinical applications continually emerge to guide and facilitate reconstructive procedures. The authors explored the possibility of fabricating a 3D printed surgical guide to define volume differences for soft tissue reconstruction in patients with facial asymmetry. The model was developed through the authors’ virtual surgical simulation and planning system that consists of computer-assisted design (CAD) and 3D printing (3DP). Three-dimensional volumetric scans of patients’ faces were analyzed with computer-aided design to quantify areas of facial asymmetry. Surgical guides with containers defining volumetric differences were fabricated using 3D printing to identify and quantify areas of soft tissue deficiency. The 3D printed patient-specific, guides were sterilized and used by the surgeon intraoperatively to accurately mark the areas of soft deficiency. Thus, facial symmetry was achieved by fat grafting the predetermined volume differences defined in the surgical guides. A postop mask was used by the surgeon at the end of the procedure and during follow-up clinic visit to verify and evaluate accurate fat grafting placement as well as to determine areas where to add volume if needed. This paper details the rational for the authors’ approach, outlines the technical planning and fabrication process of these patient-specific custom surgical guides with quantified volumetric containers and their intraoperative use by the surgeon. Despite the authors’ limited experience we conclude that the authors’ technique offer surgeons a precise means for accurate volumetric reconstruction of facial asymmetry.