11 June 2021 in Physical Review Letters
Electric-field noise due to surfaces disturbs the motion of nearby trapped ions, compromising the fidelity of gate operations that are the basis for quantum computing algorithms. We present a method that predicts the effect of dielectric materials on the ion’s motion. Such dielectrics are integral components of ion traps. Quantitative agreement is found between a model with no free parameters and measurements of a trapped ion in proximity to dielectric mirrors. We expect that this approach can be used to optimize the design of ion-trap-based quantum computers and network nodes.
25 January 2023 in AVS Quantum Science
We present an ion trap with an integrated fiber cavity, designed for strong coupling at the level of single ions and photons. The cavity is aligned to the axis of a miniature linear Paul trap, enabling simultaneous coupling of multiple ions to the cavity field. We simulate how charges on the fiber mirrors affect the trap potential, and we test these predictions with an ion trapped in the cavity. Furthermore, we measure micromotion and heating rates in the setup.
1 June 2020 in New Journal of Physics
We describe a novel method to measure the surface charge densities on optical fibers placed in the vicinity of a trapped ion, where the ion itself acts as the probe. Surface charges distort the trapping potential, and when the fibers are displaced, the ion’s equilibrium position and secular motional frequencies are altered. We measure the latter quantities for different positions of the fibers and compare these measurements to simulations in which unknown charge densities on the fibers are adjustable parameters. Values ranging from −10 to +50 e µm−2 were determined. Our results will benefit the design and simulation of miniaturized experimental systems combining ion traps and integrated optics, for example, in the fields of quantum computation, communication and metrology. Furthermore, our method can be applied to any setup in which a dielectric element can be displaced relative to a trapped charge-sensitive particle.
23 October 2019 in Physical Review Applied
We present a numerical study of a microelectromechanical-system-based design of a fiber cavity integrated with an ion-trap system. Each fiber mirror is supported by a microactuator that controls the mirror’s position in three dimensions. The mechanical stability is investigated by a feasibility analysis, which shows that the actuator offers stable support of the fiber. The actuators move the fibers’ positions continuously with a stroke of more than , with mechanical resonance frequencies on the order of kilohertz. A calculation of the trapping potential shows that a separation between the ion and the fiber consistent with strong ion-cavity coupling is feasible. Our miniaturized ion-photon interface constitutes a viable approach to integrated hardware for quantum information.
9 June 2025 in Optics Continuum
A promising solution for scalable integrated optics of trapped-ion quantum processors is curved waveguides guiding visible light within sapphire bulk material. To the best of our knowledge, no curved waveguides have been investigated in sapphire so far, and no measurements of waveguides with visible light in undoped planar sapphire substrates have been reported. Here, we demonstrate femtosecond laser writing of depressed cladding waveguides in sapphire. Laser parameters, such as pulse energy, pulse duration, and repetition rate, as well as waveguide geometry parameters, were optimized to guide 728 nm light. This resulted in single-mode waveguides with a propagation loss of 1.9(3) dB/cm. The investigation of curved waveguides showed a sharp increase in total loss for curvature radii below 15 mm. Our results demonstrate the potential of femtosecond laser writing as a powerful technique for creating integrated optical waveguides in the volume of sapphire substrates. Such waveguides could be a building block for integrated optics in trapped-ion quantum processors.