Zhamila Shakenova

Zhamila Shakenova

Auto-generated profile, based on publicly available information

Zhamila Shakenova

Kazakh Automobile and Road Institute named after L.B. Goncharov

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 July 2020 in THE BULLETIN
Verified
Journal Article
Closed access
ZSZh. N. Shakenova
Zh. N. Shakenova

28 August 2026 in Eastern-European Journal of Enterprise Technologies
Verified
Journal Article
Open access
PDF file
GSGulbarshyn Smailova
Gulbarshyn Smailova
AUAssemgul Uderbayeva
Assemgul Uderbayeva
KNKulzira Nurakhmetova
Kulzira Nurakhmetova
SKSholpan Koshanova
Sholpan Koshanova
KSKazybek Sansyzbayev
Kazybek Sansyzbayev
ZSZhamila Shakenova
Zhamila Shakenova
The object of study is the stress-strain state of the steel strip when rolling in special convex-concave rolls. The work solves the problem of the evolution of stresses and deformations during combined rolling-bending, limiting the prediction of limit states and the choice of rolling modes in rolls of unconventional geometry. It was found that with an increase in equivalent deformation from 0 to 0.358, tangential deformation increases from 0 to 0.875, and radial deformation changes from 0 to –0.803, with a decrease in thickness under the influence of compressive load. Axial deformation reaches a maximum (about 0.140) at the deformation stage and becomes negative at the final stage due to redistribution of deformations during combined rolling-bending. The tangential stress coefficient increases from 0.500 to 2.716, and the axial coefficient decreases from 0.500 to –1.955, showing a natural change in the stress state. Analysis of analytical calculations with experimental data shows discrepancies of results not exceeding 5–7%. Large degrees of deformation provide high prediction accuracy compared to the theory of small elastoplastic deformations. The obtained results justify the geometry of convex-concave rolls, in which tangential tension and radial compression is accompanied by redistribution of axial deformation and leads to the formation of a uniform stress-strain state in the deformation zone. This applies to low carbon steels, which mechanical properties are close to those of 08kp steel (DC01 according to EN 10130/AISI 1008), under isothermal rolling conditions with strip contact with rolls and deformation degrees not exceeding ε = 0.358. This approach allows to increase the stability of the technological process, predict the limit states of deformation and improve the quality of strips in industrial conditions