31 August 2023 in Eastern-European Journal of Enterprise Technologies
To improve the operational quality of paddy combine it was proposed to include additional innovative operations in plant process of pre-threshing preparation of rice biomass with anticipating seeds selection which increases seeds separation, reduces injuries, forms stable operation of threshing-separating device of combine harvester. Retrofit feeder house is a solution to ensure the stable uniform feed of assorted biomass into the threshing separation device. Equipped with tool package – harvester feeder house turned to the running control equipment for incoming flow of biomass. The movement of threshed heap inside the modified geometry of feeder house with tools effectively affect on caulis, panicle of rice – screed, and brings the biomass vibration mode i. e., lead to the dynamic separation of rice headed seeds to threshing rotor. Vibration (tossing) of biomass make it possible for free rice seeds pass through caulis to the bottom of feeder house. Development program of innovative driving devices of multifunctional rice seed harvester combine considered the development of preproduction explorational program ensuring the information on harvest loss during various rice harvesting, their separation between main harvester aggregates – collector, auger, elevator, threshing mill. It is proposed to combine, in a single complex, all the control parameters, subordinating their actions, into an active control device of the technological process, affecting the shapes of rolls formed from various varieties and yields of rice
28 August 2026 in Eastern-European Journal of Enterprise Technologies
The object of study is the stress-strain state of the steel strip when rolling in special convex-concave rolls. The work solves the problem of the evolution of stresses and deformations during combined rolling-bending, limiting the prediction of limit states and the choice of rolling modes in rolls of unconventional geometry. It was found that with an increase in equivalent deformation from 0 to 0.358, tangential deformation increases from 0 to 0.875, and radial deformation changes from 0 to –0.803, with a decrease in thickness under the influence of compressive load. Axial deformation reaches a maximum (about 0.140) at the deformation stage and becomes negative at the final stage due to redistribution of deformations during combined rolling-bending. The tangential stress coefficient increases from 0.500 to 2.716, and the axial coefficient decreases from 0.500 to –1.955, showing a natural change in the stress state. Analysis of analytical calculations with experimental data shows discrepancies of results not exceeding 5–7%. Large degrees of deformation provide high prediction accuracy compared to the theory of small elastoplastic deformations. The obtained results justify the geometry of convex-concave rolls, in which tangential tension and radial compression is accompanied by redistribution of axial deformation and leads to the formation of a uniform stress-strain state in the deformation zone. This applies to low carbon steels, which mechanical properties are close to those of 08kp steel (DC01 according to EN 10130/AISI 1008), under isothermal rolling conditions with strip contact with rolls and deformation degrees not exceeding ε = 0.358. This approach allows to increase the stability of the technological process, predict the limit states of deformation and improve the quality of strips in industrial conditions