This review paper is devoted to an extended analysis of ammonia gas sensors based on carbon nanomaterials. It provides a detailed comparison of various types of active materials used for the detection of ammonia, e.g., carbon nanotubes, carbon nanofibers, graphene, graphene oxide, and related materials. Different parameters that can affect the performance of chemiresistive gas sensors are discussed. The paper also gives a comparison of the sensing characteristics (response, response time, recovery time, operating temperature) of gas sensors based on carbon nanomaterials. The results of our tests on ammonia gas sensors using various techniques are analyzed. The problems related to the recovery of sensors using various approaches are also considered. Finally, the impact of relative humidity on the sensing behavior of carbon nanomaterials of various different natures was estimated.

In this review article, the main techniques for spectroscopic studies of gases in field conditions are considered. The issues related to the study of gas emissions from soils and the determination of their concentrations are analysed. The main types of spectroscopy used in portable devices for soil gas analysis, along with their design features and sampling approaches, are provided. Various studies aimed at optimising the operation of devices for analysing gases emitted from the soil, taking into account agronomic, agrochemical, and ecological specifics, are also presented. The effect of using different types of lasers and reflecting elements on the accuracy of optical measurements and the sensitivity to various substances in the gases is analysed.

In this paper, room-temperature chemiresistive gas sensors for NO₂ detection based on CVD-grown carbon nanofibers (CNFs) were investigated. Transmission electron microscopy, low-temperature nitrogen adsorption, and X-ray diffraction were used to investigate the carbon nanomaterials. CNFs were synthesized in a wide range of pressure (1–5 bar) by CO_x-free decomposition of methane over the Ni/Al₂O₃ catalyst. It was found that the increase in pressure during the synthesis of CNFs induced the later deactivation of the catalyst, and the yield of CNFs decreased when increasing pressure. Sensing properties were determined in a dynamic flow-through installation at NO₂ concentrations ranging from 1 to 400 ppm. Ammonia detection was tested for comparison in a range of 100–500 ppm. The obtained sensors based on CNFs synthesized at 1 bar showed high responses of 1.7%, 5.0%, and 10.0% to 1 ppm, 5 ppm, and 10 ppm NO₂ at 25 ± 2 °C, respectively. It was shown that the obtained non-modified carbon nanomaterials can be used successfully used for room temperature detection of nitrogen dioxide. It was found that the increase in relative humidity (RH) of air induced growth of response, and this effect was facilitated after reaching RH ~35% for CNFs synthesized at elevated pressures.